For the receiver:
Safety Note:
4. Operation:
·Please plug it into a safe power outlet.
·Do not expose the receiver to water spray or
water drops and do not place liquid-filled
objects such as vases or opened drink
containers on or near the receiver and the
outlet.
·Unplug the receiver immediately if you sense
a burning smell or smoke. Have qualified
personnel check the receiver before using it
again.
·Unplug the receiver from the outlet if the
doorbell system is not to be used for an
extended period of time.
For the push button:
·The push button is powered by a CR2032
battery.When exhausted, replace it using the
same type and voltage battery.
·Always insert the battery using the correct
polarity to eliminate the danger of fire.
·Keep old and new batteries away from
children.
·Old batteries should be properly disposed
using safe environmental pracitices.
·Remove the batteries from the push button
if you do not intend to use the push button
for an extended period of time.
A. Selecting the notification mode:
The doorbell receiver can notify when the
push button has been pressed by playing a
ringing sound, flashing an LED, or ringing and
flashing an LED at the same time.These are
referred to as Sound, Flash, and Sound+Flash
mode.
Note: If the performance of the push button
deteriorates or compeletely stops, the
battery might be exhausted. Please replace
with another 3V type CR2032 battery.
Receiver – Please plug into a power outlet.
Push button – Please insert the battery using the
following procedure:
· Insert a screwdriver into the small access port
at the bottom of the push button and
remove the push button’s back cover.
· Insert the 3V battery (type CR2032) into the
battery compartment, making sure the
battery surface marked with a “+”is facing
upwards.
· Reinsert the back cover, making sure it is
securely closed to ensure IP protection.
- 03 - - 04 -
