4max PP-TESC AU Series Guida alla risoluzione dei problemi
www.4-Max.co.uk
This is a guide only Without prejudice . 4-Max Models Ltd does not accept any liability whatsoever with regards to any injury or damage caused by
advice contained within or not contained within this guide. www.4-Max.co.uk
October 2018 Rev2.
How To Program a "PP-TESC**AU ESC (E
lectronic
S
peed
C
ontroller
)
This guide will go through the steps to program your PP-TESC**AU (Green Heatshrink ESC.
How to program a "PP-TESC**AU ESC using the programming card
•Position the black jumpers on the pins on the programming card (They simply pull off
and push on in your desired positions. Suggested places are shown below.
Sport and basic aerobatic models
Gliders with folding propellers
Multi motored models
3D aerobatic models
•Connect the servo type plug from the ESC to the top 3 pins on the right hand side.
Paying close attention to the polarity. Do not connect anything to the top left pins.
Please see connection photo.
www.4-Max.co.uk
This is a guide only Without prejudice . 4-Max Models Ltd does not accept any liability whatsoever with regards to any injury or damage caused by
advice contained within or not contained within this guide. www.4-Max.co.uk
October 2018 Rev2.
•Connect the ESC to any brushless motor, Doesn't matter the order of connection of the
3 wires between the motor and the ESC. (The motor must be connected to the ESC to
hear beeps, as the ESC makes the motor beep .
Connection Photo
•Connect a battery to the ESC. The ESC will then make the motor bleep once or twice
depending upon your settings (one beep for medium brake and two beeps for no brake .
That's it! you have now successfully programmed the ESC. If you do not hear any beeps
then either the motor is not connected correctly to the ESC, or there is another fault.
Please contact us.
•Disconnect battery and plug the servo type plug from the ESC back in to your throttle
channel on your receiver. Go Fly!
Indice
Altri manuali 4max Controllori
