10
English
4.3.4 Output settings
ASI
The output selection ASI disables
all RF modulation on the outputs
and all selected services will be
transmitted only through the ASI
output connector. ASI is a high
speed interface for digital TV
transport streams. Use this
output mode if you run IPTV out.
Under [ASI options] you can
select the output bitrate which is
the same bitrate as for IPTV out.
Analogue
The selection [Analogue] is set
as factory default as RF output .
You can select output [Channel
name] (E2 to E69) or [Frequency]
within steps of 1 kHz (for
example 306,167 MHz). Country
specific settings can be done by
selecting [Country]. By selecting
a specific country, transmission
standard and languages are
automatically preset. [Audio
language] gives you the choosen
language if there is more than
one language ín the received
signal.
Subtitling type, subtitle priority
and subtitle charset can be
selected.
4. Settings (continued)
Finally enter the correct Symbol rate and click on [Set] and then the Transponder
frequency and click [Set]. Click on [Reload settings] for the settings to take
effect. The available services are listed to the right.
We suggest that you consult: http://www.satcodx.com/eng/ for correct
parameters for the services you intend to use.
The input level should be higher than -65 dBm, preferably more than -50 dBm
and max -25 dBm and SNR should read more than 10.
Click [Output] to continue with the output settings.
