Acard AEC-6280 Manuale utente
Copyright 2002 ACARD Technology Corp.
ACARD Ultra ATA-133
AEC-6280
PCI-to-IDE Ultra
ATA-133 Controller
User’s Manual
Version:1.1
Copyright and Trademarks Information
The information of product in this manual is subject to change without prior
notice and does not represent a commitment on part of the vendor, who
assumes no liability or responsibility for any errors that may appear in this
manual.
ACARD and SCSIDE are the trademarks of ACARD Technology Corp.
Windows is a trademark of the Microsoft. All brand names and trademarks
are properties of their respective owners.
This manual contains materials protected under International Copyright
Laws. All rights reserved. No part of this manual may be reproduced,
transmitted or transcribed without the expressed written permission of the
manufacturer and authors of this manual.
Table of Contents
Chapter 1 Introduction ....................................... 4
1.1 Introduction ................................................................ 4
1.2 Features ...................................................................... 4
1.3 Packing List................................................................ 4
1.4 Specification .............................................................. 5
Chapter 2 Hardware Installation....................... 6
2.1 The Board Layout ...................................................... 6
2.2 Installing the IDE Adapter ......................................... 7
2.3 Cable & Power Installation ....................................... 8
2.4 Compatibility .............................................................. 9
Chapter 3 BIOS Setup ..................................... 11
3.1 Function Descriptions............................................. 11
3.1.1 IDE Deivces .......................................................... 12
3.1.2 Adapter Setup ...................................................... 12
3.1.3 Utility ..................................................................... 13
3.1.4 Load Defaults ....................................................... 14
3.1.5 Exit Setup ............................................................. 14
Chapter 4 System Installation ......................... 15
4.1 DOS Environment .................................................... 15
4.1.1 Windows 95/98/ME Environment ....................... 16
4.1.2 Windows NT Environment .................................. 19
4.1.3 Windows 2000 Environment............................... 23
4.1.4 Windows XP Environment .................................. 28
Chapter 5 Troubleshooting .............................. 34
Appendix 1 Application Utility......................... 35
Appendix 2 Making an Installation Disk ......... 36
ACARD AEC-6280
4
Chapter 1 Introduction
1.1 Introduction
ACARD AEC-6280 is a high performance PCI P&P bus master Ultra ATA-
133 adapter and on-board Flash BIOS that supports booting from ATA
device or Ultra ATA 100/66/33 and even ATA-133 hard drives.
ACARD AEC-6280 supports full-featured PCI 32-bit bus master transfer,
including PCI enhanced data transfer commands (133MB/s) and built-in
Scatter/Gather function for multitasking OS.
1.2 Features
nA standalone PCI-to-IDE controller
nSupports Ultra ATA 133/100/66/33 hard drives
nSupports ATAPI devices
nData transfer rate up to 133MB/sec
nCost-effective and high-performance
1.3 Packing List
When you open the ACARD AEC-6280 cabinet, please check the follow-
ing items.
nOne ACARD AEC-6280
nOne ATA-133 Cables
nOne Y-splitter Cable for Power
nOne User’s Manual
ACARD AEC-6280
5
1.4 Specification
Power requirement - voltage : 3.3V+/- 2%
5V+/- 2%
current : 0.5A Max.
Environment - Temperature
Operating 0 oC to 70 oC
Storage -20 oC to 85 oC
Humidity - 15% to 90%
Models:AEC-6280
Dimentions - Width: 14 cm
Height: 4.7 cm
Connectors - Dual 40 pins IDE internal connectors
ACARD AEC-6280
6
Chapter 2 Hardware Installation
ATA-133 Cable Layout:
The board layout of ACARD AEC-6280 is shown below.
IDE1: The Primary IDE port
IDE2: The Secondary IDE port
Connect to
ACARD AEC-
6280 Adapter
IDE ports
(IDE1/IDE2)
Connect to
IDE hard
drive (Slave) Connect to
IDE hard drive
(Master)
LED
IDE2 IDE1
2.1 The Board Layout
ACARD AEC-6280
7
2.2 Installing the IDE Adapter
Step 1. Turn off the computer.
Step 2. Plug out the power cord and all the
connections of external devices
from your system.
Step 3. Refer to your original case user’s
manualforhowtoopenyourcase.
Step 4. Select an unused PCI expansion
slot in your computer. Unscrew
the slot cover and remove it.
Step 5. Remove the IDE host adapter
from the anti-static bag and hold its metal bracket part.
Step 6. Insert the AEC-6280 IDE adapter into the unused PCI slot with
care on the bottom of edge. Then fit the adapter bracket on case
frame just like a slot cover.
PCI slot
n When two hard drives connect with ACARD AEC-6280 at the
same IDE port (i.e.on the same cable), the jumper setting
must be set as respectively positioning “Master” and “Slave”
on the hard drives. The two hard drives cannot be set as
“Master” or “Slave” at the same time on the same cable.
n For the hard drive or ATAPI device jumper setting (Master /
Slave), refer to hard drive or ATAPI device User’s Manual.
n In order to achieve the best performance, use the same hard
drive model, ex. Ultra ATA 66, Ultra ATA 100 or Ultra ATA 133
hard drive.
ACARD AEC-6280
8
The methods of cable connection are as follows:
Step 1. Find out pin 1 of IDE connector on the IDE device.
Step 2. Find out a color line of the internal IDE ribbon cable which
indicates pin 1 of the connector.
Step 3. Connect the internal IDE cable to the IDE device by pin-1 to pin-1.
Step 4. Connect the 4-pin power cable to the IDE device.
Master
Master
Slave
Slave
Power Cable
IDE hard drive
2.3 Cable & Power Installation
ACARD AEC-6280
9
IDE Hard Drive
nQuantum
FireBall LM series, LC series, LB series, LD series
FireBall KX series, KA series
FireBall CX series, CR series, EX series
FireBall EL series, AS 20G,60G
nSeagate
Medalist IDE series
Barracuda ATA II/III/IV series
ST320430A, ST313620A, ST3240AT,
ST38422A, ST36531A
nIBM
DTLA series, DPTA series, DTTA series, DJNA series
GXP60/75 series
nMaxtor
54098U8, 52049U4, 91366U4, 94098U8, 91020U3, 98196H8
DiamondMax60 Plus series
nFujitsu
MPF-3204AT, MPD series, MPG series
nWestern Digital
Expert 13BA, Caviar AC14300, WD300BB
WD600AB, WD800BB
Removable disk
nIOMEGA
ZIP100, ZIP250
nImation
LS120
2.4 Compatibility
ACARD AEC-6280
10
ATAPI CD-ROM
nAFREEY 50X, 52X
nASUS 40X, 50X, 52X
nAOPEN/Acer 48X, 52X
nBTC 48X, 50X, 52X, 56X
nPhilips 48X
nPioneer 32X
nSONY 48X
nTEAC 532E, 540E
ATAPI CD-R/RW
nAFREEY 50X, 52X
nASUS 40X, 50X, 52X
nHP 9100, 9300, 9500
nLITE-ON LTR-24102B
nPhilips 4X, 8X
nPLEXTOR 8432, 1210TA, 1610TA, 2410TA
nRICOH 7060A, 7120A, 7163A, 7200A, 9060A, 9120A
nSONY 120E, 140E, 145E, 160E, 168E
nTEAC W54E, W512E, W516E
nYAMAHA 8824E, 2100E, 2200E
ATAPI DVD-ROM
nAFREEY 8X, 10X
nASUS 8X, 10X, 16X
nAOPEN/Acer 16X
nRICOH 9060A, 9120A
nPioneer 113, 114, 115, 16X
nSONY 8X
For the lastest compatibility list, please visit http://www.acard.com.
Altri manuali per AEC-6280
1
Indice
Altri manuali Acard Hardware per computer
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
