Access Lighting SILO 20060LEDDMG Manuale utente

WHAT YOU NEED

• Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

• Mounting Hardware

• Crossbar plate

• 1 X Glass shade

• LED

COLLECTION

CERTIFICATION: cETLus WET

NO. 20060LEDDMG

SILO

20060LEDDMG

APPLICATION MODEL NO.

Wall Fixture

IMPORTANT SAFETY INSTRUCTIONS

MESURES DE SECURITE A RESPECTURE

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through this instruction sheet. Save this instruction sheet

and refer to it when additions to or changes in the fixture

configuration are made.

Lisez attentivement ce manuel d’instructions. Enregistrer cette feuille

d'instructions et de s'y référer lorsque les ajouts ou changements dans

la configuration de montage sont faites.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH

CIRCUIT CONDUCTOR.

CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DERIVATION SONT ADEQUATS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION

AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHERENTS

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

Read all instructions

Do not install this fixture in hazardous locations.

N'installez pas cet appareil dans des emplacements dangereux.

Do not install any fixture assembly closer than 6 inches from any

curtain or similar combustible material.

Laisser une distance d’au moins 6 pouces entre ce luminaire et la toute

surface combustible.

"WARNING Risk of Fire and Electric Shock."

“CAUTION: Risque d’ Incendie et de Choc Electriques.”

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and the U.S. National Electrical Codes (NEC). These fixtures are

intended for mounting to a standard 4” metal octagon outlet box.

The box must be directly supported by the building structure and U.L.

Recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

Recommended Dimmers

Lutron Maestro MACL-153MH

Lutron Maestro MAELV-600-WH

Leviton SureSlide NO.6672

MOUNT CROSSBAR AND WIRE CONNECTIONS

If there is an existing fixture remove it. Expose the supply wires

from the J-box.

Mount the crossbar to the J-box with the

supplied screws. Connect the black supply wire to the black

fixture wire. Secure with the supplied wire nuts. Connect the

white supply wire to the white fixture wire. Secure with the

supplied wire nuts. Attach the green J-Box wire around

green hexagonal head screw or connect it to the green

supply grounding wire of the fixture.

Secure all wire with electrical tape (not supplied).

Tuck all wires carefully into the J-Box.

WHAT YOU NEED

• Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

CERTIFICATION: cETLus WET NO.

20060LEDDMG

MOUNT FIXTURE TO CROSSBAR

Position the fixture over the crossbar.

Align the holes in the center of the

fixture and secure with the supplied screws.

SECURE THE GLASS SHADE

Place the glass shade up to the fixture, rotate the

glass shade so that the glass is secure to the fixture.

**This fixture is wet location rated. In order to ensure

that moisture does not enter the outlet box and cause

a short circuit, clear caulking should be used to seal the

space between the fixture mounting bracket and the

wall. Ensure that a space is left at the bottom to allow

for the escape of moisture. It is recommended that

Outdoor Silicon Sealant is used for that purpose**

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW ACCESS LIGHTING FIXTURE

If the fixture is to be removed or replaced,

please ensure that the electricity is

switched off and that the fitting is cool

before touching it.

CAUTION

VER: 18.12.1

Indice

Altri manuali Access Lighting Apparecchio di illuminazione

Access Lighting

Access Lighting 50480 Istruzioni per l'installazione

Access Lighting

Access Lighting 20368MG Istruzioni per l'installazione

Access Lighting

Access Lighting 20355 Istruzioni per l'installazione

Access Lighting

Access Lighting 62236 Istruzioni per l'installazione

Access Lighting

Access Lighting ATOM 31000LEDSWACD Manuale utente

Access Lighting

Access Lighting 30111 Manuale utente

Access Lighting

Access Lighting 31027 Istruzioni per l'installazione

Access Lighting

Access Lighting NIDO 63961LEDD Manuale utente

Access Lighting

Access Lighting NITRO 2 62293 Manuale utente

Access Lighting

Access Lighting 20347 Manuale utente

Manuali Apparecchio di illuminazione popolari di altre marche

Emos

Emos CLASSIC ZY1431T Manuale utente

Westinghouse

Westinghouse Outdoor Lighting Fixture Manuale utente

Hedler

Hedler C 12 silent Manuale utente

Blizzard Lighting

Blizzard Lighting Puck: CSI Manuale utente

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manuale utente

Lightmaxx

Lightmaxx Shaft 5R Manuale utente

Triarch

Triarch 31083 Manuale utente

Philips

Philips 32614 Series Manuale utente

IKEA

IKEA TIVED Manuale utente

Lightolier

Lightolier LP200 Manuale utente

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manuale utente

Martin

Martin MAC 250 Krypton Manuale utente

Cooper Lighting

Cooper Lighting Halo L3232E Manuale utente

Stageline

Stageline ODW-2410RGBW Manuale utente

Light Sky

Light Sky Tornado Series Manuale utente

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Manuale utente

Lightolier

Lightolier Lytespan 83ED17S Manuale utente

Lightolier

Lightolier Calculite CS8226 Manuale utente