Access Lighting TRIDENT 20389LEDDMGLP Manuale utente

CERTIFICATION: cULus WET

INSTALLATION INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

MESURES DE SECURITE A RESPECTURE

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through this instruction sheet. Save this instruction sheet

and refer to it when additions to or changes in the fixture

configuration are made.

Lisez attentivement ce manuel d’instructions. Enregistrer cette feuille

d'instructions et de s'y référer lorsque les ajouts ou changements dans

la configuration de montage sont faites.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH

CIRCUIT CONDUCTOR.

CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DERIVATION SONT ADEQUATS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONTSTRUCTION

COLLECTION

APPLICATION MODEL NO.

AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHERENTS

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations that

may occur. It must be understood that common sense, caution and care,

are factors that can’t be built into any product. These factors must be

supplied by the person(s) caring for and operating the fixture.

Read all instructions

Do not install this fixture in hazardous locations.

N'installez pas cet appareil dans des emplacements dangereux.

Do not install any fixture assembly closer than 6 inches from any

curtain or similar combustible material.

Laisser une distance d’au moins 6 pouces entre ce luminaire et la toute

surface combustible.

"WARNING Risk of Fire and Electric Shock."

“CAUTION: Risque d’ Incendie et de Choc Electriques.”

WHAT WE PROVIDE

•Mounting Hardware

•Fixture Assembly

•Rubber gasket

•Back plate

•2 X A19 E-26 LED

bulbs

WHAT YOU NEED

•Screwdriver

•Wire Cutters

•Wiring Supplies as Specified

by Electrical Code

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and the U.S. National Electrical Codes (NEC). These fixtures are

intended for mounting to a standard 4” metal octagon outlet box.

The box must be directly supported by the building structure and U.L.

recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

WALL FIXTURE

20389LEDDMGLP

NO.

20389LEDDMGLP

TRIDENT

CERTIFICATION: cULus WET

PREPARE THE FIXTURE AND INSERT THE BULBS

If there is an existing fixture remove it. Expose the supply

wires from the J-box and pass the wires through the

designated hole in the universal plate rubber, gasket and

fixture back plate. Mount the universal plate, rubber gasket

and back plate with the supplied screws. Unscrew the two

screws on the top and bottom of the fixture that are securing

the glass covers to the fixture.

Insert the bulbs into each socket.

DO NOT EXCEED THE MAXIMUM WATTAGE

AS STATED ON THE WARNING LABEL.

Replace the glass covers and secure with supplied screws.

MAKE WIRE CONNECTIONS

Connect the black supply wire to the black fixture wire.

Secure with the supplied wire nuts. Connect the white supply

wire to the white fixture wire. Secure with the supplied wire

nuts. Attach the green J-Box wire around green hexagonal

head screw or connect it to the green supply grounding

wire of the fixture. Secure all wires with electrical tape (not

supplied). Tuck all wires carefully into the J-box.

MOUNT THE FIXTURE

Place the fixture canopy over the fixture back plate such

that the fixture is flush against the wall. Insert the supplied

screws into the holes in the fixture canopy ensuring that they

fit into the indented area on the back plate.

*This fixture is wet location rated. In order to ensure that

moisture does not enter the outlet box and cause a short

circuit, clear caulking should be used to seal the space

between the fixture mounting bracket and the wall.

Ensure that a space is left at the bottom to allow the

escape of moisture. It is recommended that

Indoor/Outdoor Silicon Sealant be used for this

purpose**

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEWACCESSLIGHTINGFIXTURE

Dimmable fixture - see attached list for compatible dimmer switches. VER: 17.10.1

NO. 20389LEDDMGLP

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Access Lighting Luce esterna

Access Lighting

Access Lighting NAUTICUS 20290LEDDLP Manuale utente

Access Lighting

Access Lighting Nauticus 20294LEDDLP Manuale utente

Access Lighting

Access Lighting Bermuda Series Manuale utente

Access Lighting

Access Lighting 20370MG Istruzioni per l'installazione

Access Lighting

Access Lighting 20351 Manuale utente

Access Lighting

Access Lighting 20043LEDDMG Manuale utente

Access Lighting

Access Lighting Nostalgia 23766 Manuale utente

Access Lighting

Access Lighting SLANT DLC 20786LED Manuale utente

Access Lighting

Access Lighting Oslo 62580LEDDLP Manuale utente

Access Lighting

Access Lighting SQUARE 20399LEDMG Manuale utente

Manuali Luce esterna popolari di altre marche

Sealey

Sealey LED37 Manuale utente

nordlux

nordlux VEJERS Guida utente

SImx

SImx ELITE LED LHTC637 Manuale utente

GEV

GEV CAROLINE 10833 Manuale utente

NEBO

NEBO NEB-LSP-0020 Manuale utente

WE-EF

WE-EF PFL540 LED Manuale utente

Lindby

Lindby 9949029 Manuale utente

HEPER

HEPER DOGO Side LW6048.585-US Istruzioni per l'installazione e il funzionamento

HEPER

HEPER LW8034.003-US Istruzioni per l'installazione e il funzionamento

Maretti

Maretti VIBE S 14.6080.04.A Manuale utente

BEGA

BEGA 84 253 Manuale

HEPER

HEPER MINIMO Istruzioni per l'installazione e il funzionamento

LIGMAN

LIGMAN BAMBOO 3 Manuale utente

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuale utente

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuale utente

urban ambiance

urban ambiance UQL1273 Manuale utente

TotalPond

TotalPond 52238 Manuale utente

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuale utente