Access One WVD-S200P Manuale utente
Revision A
WVD-S200P
Read and follow all UL and Safety Standards before installing. Refer to the manual and qualified personnel
for assistance. DO NOT install this device unless all entrapment and pinch points are eliminated.
Quick Reference
Installaon Instrucons
WARNING!
Protect against all pinch & entrapment points. If entrapment points are not protected, DO NOT
install this product.
This device is intended for vehicular traffic only. Keep all pedestrian traffic including bicycles away
ASSEMBLING THE SENSOR:
The sensor consists of a battery,
PCB, antenna ring, and antenna.
To assemble the S200P:
1. Place the battery at the
bottom of the housing with
the wire leads at the top of
the battery.
2. Using the long grooves,
slide the circuit board
(PCB) into the housing.
The battery connector
should be at the bottom
and the learn button at the
top.
3. Slide the antenna ring over
the antenna. The lip on
the ring should be on the
bottom so the antenna
rests on it.
4. Gently fold the antenna
wire and place the
antenna in the antenna
ring on top. The antenna
should be resting on the lip
WVD-S200P
Antenna Top View:
Antenna Ring goes
in first. Antenna sits
on top of ring edge
to prevent antenna
from rocking or
sliding to the side of
the circuit board.
Altri manuali Access One Sensore di sicurezza
