32
Safety Instructions Installation AVH23
Important Safety Information – Please Read before
Proceeding
The information contained in these installation
instructions must be read carefully before any attempt to
install the hand dryer.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Failure to accurately follow these instructions may result
in the incorrect operation of the unit, damage to property
and/or personal injury.
Addvent will not be held liable for any damage to
property or personal injury as a result of failure to comply
with the instructions contained herein.
All electrical installation and repair work should be carried
out by a qualified electrician in accordance with current
UK IEE regulations and any local codes or regulations.
Any maintenance to this appliance should be carried out
by a qualified electrician.
This product must be earthed.
Isolate power to the device before installation or
servicing.
Check that the electrical supply corresponds to that
shown on the rating plate on the device.
NOT to be used for any purpose other than drying hands.
Before installation
Be sure to select a suitable position to
install the hand dryer – figure 1.
Make certain that you have all the parts
and appropriate tools for installation.
Ensure that the power is disconnected
before installation.
Installation
Electrical
The electrical supply required for this unit is
(single phase) 220V AC, 50Hz.
NOTE: a circuit breaker (RCCB) may be
required in certain installations.
Installation
Firstly, remove the outer casing by undoing
the two screws in the bottom of the
casing– see figure 1. Then detach the
connecting cable – see figure 2
Using figure 3 as a guide, offer up the
backplate in the preferred mounting
position and mark the position for the 4
holes.
Drill the holes and affix wall plugs.
Mount the backplate and fix screws,
making sure to pull the power cable
through its hole in the backplate – see
figure 4
Ensure the backplate is secure, reconnect
the connecting cable, and then replace the
outer casing and fix the screws on the
bottom surface.
WARNING
FIG 1
FIG 2
FIG 4
FIG 3
