5. Fill in clean, drinkable tap water into the Water Filtration Container until it is full.
6. Allow 10-15 minutes for the water to be filtered anf flow into the dispenser’s heating and
cooling compartments. Make sure water can be dispensed from the HOT Gand COLD H
water taps before proceeding to the next step.
7. Turn on the main power switch, the compressor will start working to chill the COLD Water
Tank.
8. Turn on the HOT Water Heater Switch M.
9. The POWER Indicator Light Cwill remain lit.
10. The HOT and COLD Water Indicator Light will light up intermittently with reference to the
present temperature.
NOTE:
P
lease allow at least a 5 minute interval turning on the Main Power Switch once it is off.
The COLD Water Thermostat Lis already set for optimal performance in the factory.
Please do not adjust the setting.
WARNING:
Do Not Plug the System into the socket until water flows through both taps.
PROPER CARE AND CLEANING
WARNING:
Always remove the plug from the electric socket before performing any
maintenance or cleaning.
General
1. For best results, it is recommended to change the filters every 2650 litres or every 3 months,
whichever comes first.
2. It is also recommended to wash the water containers, the filters and the dispenser every
month, including draining off all water within the dispenser by releasing water through the
Water Drainage Outlet P.
Beware: Water flowing out can be very hot.
3. The spilled water in the Drip Tray Imust be removed and cleaned regularly.
Cleaning inner Stainless Steel COLD Water Tank
1. Remove the 2 screws (marked on page 2) on the rear side on
the Top Cover Assembly Kwith a Phillips Screwdriver.
2. Lift up the Top Cover Assembly from the rear and detach
from the dispenser.
3. Turn Part S (marked BLACK)
anti-clockwise and the Assembly will
come apart.
4. Remove the Separating Disc by pulling up
vertically.
5. Clean the Stainless Steel COLD Water Tank with a clean cloth
or kitchen towel. DO NOT USE any chemical or detergent.
6. Position back all parts and secure Top Cover Assembly with
the screws at the rear side of the dispenser.
Cleaning the Condenser Coil
We recommend that you move the dispenser away from the wall
and vacuum or brush the coil Qat the rear fo the unit at least 4
times a year. Some operating environments require more
frequent cleaning.
Stainless Steel
COLD Water Tank
Separating Disc
Separating Disc
Support
(DO NOT REMOVE)
Water Filtration
Container Holder
Part S
Part T
Top Cover
