Advantech IPC-613 Manuale utente
IPC-613
2U e-Server Chassis
Copyright Notice
This document is copyrighted, June 2000, by Advantech Co., Ltd. All rights are reserved. Advantech
Co., Ltd. reserves the right to make improvements to the products described in this manual at any time
withoutnotice.
No part of this manual may be reproduced, copied, translated, or transmitted in any form or by any
means without the prior written permission of Advantech Co., Ltd. Information provided in this
manual is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no responsibili-
ty for its use, nor for any infringements of the right of third parties which may result from such use.
Acknowledgments
IPC-613 is trademarks of Advantech Co., Ltd.
Note: The information in this document is provided for reference only. Advantech does
not assume any liability arising out of the direct or indirect use of the information
or products described herein.This manual is subject to change without notice.
Part No. 2002061300
1st Edition Printed in Taiwan June 2000
Contents
Chapter 1 General Information ................................................. 1
1.1 Introduction ..................................................................................... 1
1.2 Specifications ................................................................................. 1
1.3 Dimensions ..................................................................................... 2
Chapter 2 System Setup ........................................................... 3
2.1 Removing the Cover ........................................................................ 3
2.2 Drive Bay ........................................................................................ 4
2.3 Installing A Motherboard .................................................................. 5
2.4 Installing the Riser Card .................................................................. 6
2.5 Temperature Setting ........................................................................ 7
Appendix A Riser Card ................................................................. 9
Appendix B Safety Instructions ..................................................11
B.1 English .......................................................................................... 11
B.2 German - Wichtige Sicherheishinweise ......................................... 12
Figures
Figure 1-1: IPC-613 dimensions ....................................................................................................................... 2
Figure 2-1: Upper cover removing ..................................................................................................................... 3
Figure 2-2: Hot-swap hard disk drive bay ......................................................................................................... 4
Figure 2-3: IPC-613 with server motherboard .................................................................................................... 5
Figure 2-4: Riser card on the motherboard ....................................................................................................... 6
Figure 2-5: Temperature Setting ....................................................................................................................... 7
Figure 2-6: System monitoring alarm board ..................................................................................................... 7
IPC-613 User's Manual
1
Chapter 1 General Information
1.1 Introduction
The IPC-613 is a 2U high, rack-mount e-Server chassis for high-density internet services. Engineered
for service providers and enterprises, the IPC-613's rack-mount 2U form factor is best for stacking
servers as services grow. The IPC-613 is designed to accommodate ATX motherboards. With various
configuration possibilities, the IPC-613 provides the flexibility and high performance at the same time.
1.2 Specifications
•Construction: Heavy-duty steel
•Disk drive capacity: Four optional hot-swap 3.5" hard disk drive space, one 5.25" CD-ROM drive
and one 3.5" floppy disk drive
•Expansion slots: Two PCI expansion slots on the PCI riser card
•Indicators: LEDs for power, fan, and temperature
•Controls: Momentary power switch and alarm reset switch on front panel
•Cooling fan: Three 38.6 CFM cooling fans, 115.8 CFM in total
•Weight: 10 kg (22 lbs)
•Dimensions (W x D x H): 482 x 595 x 88 mm (19" x 23.4" x 3.5")
•Interior paint color: Black 4C 2X; brushed finish, Ni
Power supply
•Output rating: 300 W
•Input rating: 100/200 VAC
•Output voltage: +3.3 V @ 16 A, +5 V @ 26 A, +12 V @ 10 A, -5 V @ 0.25 A, -12 V @ 1 A, +5
VSB @ 1.5 A
•Minimum load: +5 V @ 1 A, +12 V @ 0.5 A
•MTBF: 50,000 @ 50° C
•Safety: CE / UL / CUL
Environmental specifications
•Operating temperature: 0 ~ 45° C (32 ~ 113° F)
•Relative humidity: 10 ~ 95% @ 40° C, non-condensing
•Safety: UL / CE approved
•CE compliant
2
IPC-613 User's Manual
1.3 Dimensions
Unit: mm (inches)
Figure 1-1: IPC-613 dimensions
IPC-613 User's Manual
3
Chapter 2 System Setup
The following procedures are provided to assist you in installing drives and plug-in cards into the
IPC-613.
2.1 Removing the Cover
1. Unscrew the screws at the rear side of the chassis.
2. Slide the upper cover backwards.
3. Lift up the upper cover to open the chassis.
Figure 2-1: Upper cover removing
4
IPC-613 User's Manual
2.2 Drive Bay
The IPC-613 supports four hard disk drives, one CD-ROM drive and one floppy disk drive. There are
two types of the IPC-613 available: IPC-613 and IPC-613-SCA. The IPC-613-SCA provides a SCA-2
backplanes and therefore support four hot-swap hard disk drives.
Please notice that the IPC-613 support two 3.5", 1" height SCSI hard disk drives with 80-pin SCA-2
connecotrs and two 3.5" 1.6" height SCSI hard disk drives with 80-pin SCA-2 connectors.
In order to install the hard disk drives in the chassis, please follow the following procedures.
1. Unscrew the screws on the hard disk trays and pull them out.
2. Put hard disk drives in the hard disk racks and fasten them with screws.
3. Slide the hard disk racks into the drive bay.
Figure 2-2: Hot-swap hard disk drive bay
IPC-613 User's Manual
5
2.3 Installing A Motherboard
The IPC-613 support ATX motherboards. Please contact Advantech for recommended motherboard
solutions.
Figure 2-3: IPC-613 with server motherboard
6
IPC-613 User's Manual
2.4 Installing the Riser Card
One riser card is shipped with the IPC-613. This riser card can support two PCI expansion slots.
Please refer to Figure 2-4 to install the riser card.
Figure 2-4: Riser card on the motherboard
Altri manuali Advantech Telaio
Advantech
Advantech HPC-8424 Manuale utente
Advantech
Advantech ACP-4340 Manuale utente
Advantech
Advantech HPC-7484 Manuale utente
Advantech
Advantech IPC-616 Manuale utente
Advantech
Advantech IPC-622 Series Manuale utente
Advantech
Advantech ATM-4023 Manuale utente
Advantech
Advantech EPC-S101 Manuale utente
Advantech
Advantech PCE-5B06-00A1E Manuale di installazione e funzionamento
Advantech
Advantech IPC-6806S Manuale utente
Advantech
Advantech IPC-3026 Manuale utente
Advantech
Advantech ACP-4020 Manuale utente
Advantech
Advantech IPC-3012 Manuale utente
Advantech
Advantech ACP-4320 Manuale utente
Advantech
Advantech ACP-2000 Manuale utente
Advantech
Advantech ACP-5260 Manuale utente
Advantech
Advantech ACP-4010 Manuale utente
Advantech
Advantech ITA-2000 Manuale utente
Advantech
Advantech IPC-610-H Manuale utente
Advantech
Advantech IPC-6025 Manuale utente
Advantech
Advantech HPC-8208 Manuale utente
