Advantech MIC-770 Manuale di installazione e funzionamento

MIC-770 Startup Manual 1

Before you begin installing your card, please make sure

that the following items have been shipped:

1. MIC-770 bare-bone system x 1

2. Startup manual EN\CN\TC for MIC-770 1st Ed

P/N: 2041077000

3. 4-pin Phoenix connector P/N: 1652003234

4. Mounting bracket x2 P/N: 1960070543T001

5. SATA cable x1 P/N: 1700013095

6. SATA power cable x 1 P/N: 1700024372-01

If any of these items are missing or damaged, please con-

tact your distributor or sales representative immediately.

Note: Acrobat Reader is required to view any PDF ﬁle.

Acrobat Reader can be downloaded at: get.

adobe.com/reader (Acrobat is a trademark of

Adobe)

MIC-770

Intel

Generation Core™ i Socket Compact

Fanless Computer

Startup Manual

Caution:

DANGER OF EXPLOSION IF BATTERY IS INCOR-

RECTLY REPLACED. REPLACE ONLY WITH THE

SAME OR EQUIVALENT TYPE RECOMMENDED

BY THE MANUFACTURER, DISCARD USED BAT-

TERIES ACCORDING TO THE MANUFACTURER’S

INSTRUCTIONS.

Attention:

DANGER D’EXPLOSION SI LA BATTERIE EST

INEXACTEMENT REMPLACÉE. REMPLACEZ

SEULEMENT AVEC LA MÊME CHOSE OU LE TYPE

ÉQUIVALENT RECOMMANDÉ PAR LE FABRICANT,

JETTENT LES BATTERIES UTILISÉES INSTRUC-

TIONS DE S SELON FABRICANT DES’.

Processor System

•Intel®8th generation Core™ i socket CPU (LGA1151)

Memory

•Supports dual channel DDR4 SODIMM-2666 MHz,

16 GB per slot without ECC function; Max. capacity

is 32GB

Graphics

• Q370: Intel®HD Graphics 630, supports DirectX 12

• H310: Intel®HD Graphics 610, supports DirectX 12

Serial Ports

•2 x RS-232/422/485, RS-485 supports automatic ﬂow

control

Ethernet

• Interface: 10/100/1000 Mbps

• Controller:

Q370 LAN1: Intel®I219LM, LAN2: Intel®i210IT

H310 LAN1: Intel®I219V, LAN2: Intel®i210IT

Storage

• Internal 2.5” Storage Bay: 1

• mSATA: 1

Front I/O

• Display: 1 x VGA, 1 x HDMI

• USB: Q370: 2 x USB3.1 , 6 x USB3.0

H310: 4 x USB 3.0 and 4 x USB 2.0

• Serial: 2 x RS-232/422/485

• Audio: Line-out/Mic-in

Power Requirement

• Power type: ATX/AT

• Power input Voltage: 9-36 VDC

• Minimum Power Input: 9VDC 16A - 36VDC 5A

This product is intended to be supplied by a UL certiﬁed

power supply or UL certiﬁed DC source rated 19Vdc,

7.89A minimum, TMA 50 °C minimum. If you need further

assistance, please contact Advantech.

Specications

Packing List

2 MIC-770 Startup Manual

Miscellaneous

•Power Switch

(Orange: System standby/Green: System Power boot)

•COM1 TX & RX LED; COM2 TX & RX LED; Storage Status

LED

Environment

• Operating Temperature:

TDP 35W CPU: -10~50°C

TDP 65W CPU: -10~40°C (not supported by i7)

Note: Safety Certiﬁcation Test Temperature: safety max

50 °C with SSD (TDP 35W CPU)

• Storage Temperature: -40 ~ 85 °C (-40 ~ 185 °F)

• Relative Humidity: 95% @ 40° C (non-condensing)

Physical Characteristics

• Dimensions (WxHxD): 77 x 192 x 230 mm

• Weight: 2.8 kg (6.17 lbs)

Jumpers and Connectors

The board has a number of jumpers that allow you to con-

ﬁgure your system to suit your application. The table below

lists the function of each of the jumpers and connectors.

Connectors

Label Function

VGA1 VGA Connector

HDMI1 HDMI connector

COM 12 RS-232/422/485

COM 34 RS-232

USB C1 USB 3.0

USB C2 USB 3.0

USB C3 USB3.1 and USB3.0 (Q370) or

USB2.0 (H310)

LAN 1 Intel i219LM (Q370) or Intel i219V (H310)

LAN 2 Intel i210IT

Audio Audio Jack (Line-out, Mic-in)

LED 6 COM 1/2 TX; RX; Storage device status

DC 9-36V Power connector

AT Module ATX Module

PSON1: System AT/ATX Module Selection

Function Jumper Setting

1-2 AT module

2-3 ATX module (Default)

The computer is supplied with a battery-powered realtime

clock circuit. There is a danger of explosion if battery is

incorrectly replaced. Replace only with same or equivalent

type recommended by the manufacturer. Discard used

batteries according to manufacturer’s instructions.

This device complies with the requirements in Part 15 of

the FCC rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference;

2. This device must accept any interference received,

including interference that may cause undesired

operation.

Memory Installation

MIC-770 supports DDR4 SO-DIMM non-ECC type memory

modules. If you need a detailed memory support list,

please contact your distributor or sales representative to

order compatible memory modules.

Power

Line out

LAN1/LAN2

Chassis GND

VGA

9-36 VDC

LED

COM1

TX/RX

COM2

TX/RX

DATA COM1/2

USB3.1

USB3.0/2.0

/3.0

HDMI

Specications (Cont.)

Declaration of Conformity

System I/O Interface

Simple Maintenance Process

Battery

MIC-770 Startup Manual 3

1. Undo 4 screws and remove the bottom cover.

2. Undo 4 screws to remove the storage tray.

3. Undo 3 screws to remove memory thermal cover.

4. Afﬁx thermal pad (P/N: 1990019498N000) on memory

and assemble memory.

Note : Thermal pad and memory thermal cover must

be fully mated and compacted.

Storage Installation

1. Undo 4 screws and remove the bottom cover

2. Undo 4 screws to remove storage tray.

3. Secure the 4 x screws (P/N:1930002235)

4. Assemble SATA cable/power cable and replace stor-

age tray; secure with 4x screws.

5. Replace the bottom cover.

Mini-PCIE Installation

MIC-770 supports one full size Mini-PCIE.

1. Undo 4 screws and remove the bottom cover.

2. Install the module in the Mini-PCIe socket and secure

with screws.

3. Replace bottom cover and secure with screws.

Internal USB 2.0 Installation

1. Undo 4 screws and remove the bottom cover.

2. Loosen the screw and adjust bracket size in accor-

dance with USB dongle size.

3. Install USB dongle in the ﬁrst socket. Only ﬁrst socket

has this function.

4. Secure with screw and replace bottom cover and

attach with screws.

CPU Installation

1. Undo 4 screws and remove the bottom cover.

2. Undo 4 screws to remove storage tray.

3. Undo 4 screws in the corner of chassis.

4. Undo 4 screws around CPU to release AL heatsink.

5. Remove AL heatsink and install CPU.

6. Smear thermal grease onto CPU.

7. Replace AL heatsink, storage tray and bottom cover.

Mounting Kit Installation

1. Take the mounting kit from accessory box.

2. Secure the 4x screws (P/N: 1930007259-01, M4x4L

F/S D=8.5 H=1.5 (2+) ST/H BZn-NK) and install system

on table.

Simple Maintenance Process (Cont.)

4 MIC-770 Startup Manual

1. Read these safety instructions carefully.

2. Keep this Startup Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning. Use a damp cloth. Do not use liquid or spray detergents

for cleaning.

4. For plug-in equipment, the power outlet socket must be located near the equipment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Dropping it or letting it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the equipment from overheating. DO NOT COVER THE

OPENINGS.

8. Make sure the voltage of the power source is correct before connecting the equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not place anything over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the power source to avoid damage by transient overvolt-

age.

12. Never pour any liquid into an opening. This may cause ﬁre or electrical shock.

13. Never open the equipment. For safety reasons, the equipment should be opened only by qualiﬁed service personnel.

14. If one of the following situations arises, get the equipment checked by service personnel:

•The power cord or plug is damaged.

•Liquid has penetrated into the equipment.

•The equipment has been exposed to moisture.

•The equipment does not work well, or you cannot get it to work according to the user’s manual.

•The equipment has been dropped and damaged.

•The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STORAGE TEMPERATURE MAY GO BELOW

-40° C (-40° F) OR ABOVE 85° C (185° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT SHOULD BE IN

A CONTROLLED ENVIRONMENT.

16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR

EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER, DISCARD USED BATTERIES ACCORDING TO THE

MANUFACTURER’S INSTRUCTIONS.

17. The sound pressure level at the operator’s position according to IEC 704-1:1982 is no more than 70 dB (A).

18. RESTRICTED ACCESS AREA: The equipment should only be installed in a Restricted Access Area.

DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech disclaims all responsibility for the accuracy

of any statements contained herein.

Safety Instructions

MIC-770 Startup Manual 5

IO Connectors

System Dimensions

Internal USB 2 0 DDR4 socket

US M

MiniPCIe support mSATA

MiniPCIe support USIM

COM5/6

COM3/4

GPIO

eFuse

LPC

HDMI/DVI Con

ATX/AT jumper

Clear CMOS

Remote

USB switch

Altri manuali per MIC-770

Indice

Altri manuali Advantech Scrivania

Advantech

Advantech UNO-2271G Manuale utente

Advantech

Advantech ITA-3650 Series Manuale di installazione e funzionamento

Advantech

Advantech EPC-R4710 Manuale utente

Advantech

Advantech ARK-3531 Series Manuale utente

Advantech

Advantech TPC-1570H Manuale utente

Advantech

Advantech DLoG DLT-V72 Series Manuale utente

Advantech

Advantech UTC-318 Series Manuale utente

Advantech

Advantech POC-W181 Manuale di istruzioni

Advantech

Advantech UNO-1150 Manuale utente

Advantech

Advantech ITA-1711 Series Manuale di installazione e funzionamento

Advantech

Advantech EPC-T2286 Series Manuale utente

Advantech

Advantech ARES-5221B Manuale utente

Advantech

Advantech UBC-220 Manuale utente

Advantech

Advantech UNO-4673A Series Manuale utente

Advantech

Advantech EPC-U2117 Manuale utente

Advantech

Advantech TPC-307W Manuale utente

Advantech

Advantech SOM-6832 Manuale utente

Advantech

Advantech SKY-642 4U Manuale di installazione e funzionamento

Advantech

Advantech UTC-520FP-IKA0E Series Manuale di installazione e funzionamento

Advantech

Advantech POC-624-12 Series Manuale utente

Advantech

Advantech PPC-179T Manuale utente

Advantech

Advantech TPC-5212W Series Manuale utente

Advantech

Advantech ARK-1221L Manuale utente

Advantech

Advantech UTC-515 Manuale utente

Manuali Scrivania popolari di altre marche

HP m9060n - Pavilion - Elite Scheda tecnica

Asus

Asus E210 Series Manuale utente

Dell

Dell Inspiron 600m Manuale utente

Dell

Dell Inspiron 3662 Manuale utente

TotalFlow

TotalFlow uFLO Manuale utente

HP Presario SV7000 - Desktop PC Manuale utente

HP ProDesk 400 G5 Manuale

Logitech

Logitech MK320 Manuale utente

Dell

Dell XPS 730 H2C Manuale utente

Sony

Sony Vaio Series Manuale utente

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manuale utente

Alto

Alto MD 250 Manuale utente

Lenovo

Lenovo ThinkCentre Edge 72 Manuale

Lenovo

Lenovo ThinkStation D20 Manuale

Arbor Technology

Arbor Technology FPC-7800 Series Manuale utente

Sony

Sony VAIO VGX-TP1 Series Manuale utente

Asus

Asus Eee Box B204 Manuale utente

Dell

Dell Optiplex 9010 All In One Manuale utente