Specifications are subject to change without notice
V1.0
Specifications (Column Installation)
30” Stainless Steel Microwave Trim Kit
1.Unscrew the 4 screws holding the 2 pieces of wood in place, and retain the screws.
2.Screw the 2 pieces of wood onto the base of the cabinet. The wooden strips should touch the
inside of the front of the MWTK-76, and be positioned with the centre of the wooden strips
(1817/64”= 46.4cm) apart.
3.Being careful not to scratch the microwave door, lift the microwave onto the wooden strips, and
move it back about 2 inches.
4.Place the MWTK-76 into position. Use the 4 screws and screw them through the flanges into the
side gables.
5.Pull the microwave forward, and align the front of the microwave with the front of the MWTK-76.
6.To stop the microwave from sliding backwards whilst opening it, it might be necessary to attach a
piece of wood behind the feet of the microwave, on the wooden supports.
7.Air must be able to flow from the microwave upwards and into the room, or roof space. Failure to
comply will void the manufacturer’s warranty on the microwave oven.
INSTALLATION
