Top Grade Air Powered Spray Gun A604
2. Never use oxygen, combustible or any other bottle gas as a power source or would
cause explosion and serious personal injury. (see fig 2)
3. Fluid and solvent can be highly flammable or combustible. Use in well-ventilated spray
booth and avoid any ignition sources, such as smoking, open flames and decrial
hazard. (see fig 3)
4.Disconnect tool from air supply hose before doing tool maintenance and during
non-operation, for emerge stop and prevention of unintended operation, a ball valve
near the gun to air supply is recommend.
5. Use clean, dry and regulate compressed air rated at 2.0bar, never exceed maximum
permissive operating pressure (see fig 4)
6. Never use homogenate hydrocarbon solvent, which can chemically react with
aluminum and zinc parts and chemically compatible with aluminum and zinc pats.
7. Never point gun at you and others at any time.
8. Before operating the tool, make sure all the screws & caps are securely tightened in case of leaking;
9. Before painting, make inspection for free movement of trigger and nozzle to insure tool can operate well.
10. Never modify this tool for any applications. Only use parts, nozzles and accessories recommended and
accessories recommended by manufactures.
※Operating Instructions
This tool applies to operate on clean, dry and compressed air at regulated pressure at 2.0bar.Too low or too
high pressure is not allowed.
Check and replace any damaged or worn parts on the tool, make sure the trigger and nozzle can operate well.
Connect the gun to air supply, fluid cap, container and air hose should be connected tightly with spray gun.
When painting, Grip the gun keeping perpendicular with spraying area then move it parallel for several times,
the trigger should be locked before the stroke ended. Keep the appropriate distance of 6-8 inches between
gun and raying area, according the atomization pressure and work demand. Just like the fig5 show.
Fig 5
