Aewin Technologies AW-A793 Manuale utente

Control Board

Model Number AW-A793

Intel® Pentium® M Embedded SBC with Ten 64-bit GbE ports, Four

10/100LAN & SSD

User’s Manual

Version 1.0

User’s Manual

Manual Edition 1.0, January, 2005

This document contains proprietary information protected by copyright. All rights

are reserved; no part of this manual may be reproduced, copied, translated or

transmitted in any form or by any means without prior written permission of the

manufacturer.

The content of this manual is intended to be accurate and reliable; the original

manufacturer assumes no responsibility for any inaccuracies that may be contained

in this manual. The original manufacturer reserves the right to make improvements

to the products described in this manual at any time without prior notice.

Trademarks

IBM, EGA, VGA, XT/AT, OS/2 and PS/2 are registered trademarks of International

business Machine Corporation

Award is a trademark of Award Software International, Inc

Intel is a trademark of Intel

RTL is a trademark of Realtek

VIA is a trademark of VIA Technologies, Inc

Microsoft, Windows, Windows NT and MS-DOS are either trademarks or registered

trademarks of Microsoft Corporation

All other product names mentioned herein are used for identification purpose only

and may be trademarks and/or registered trademarks of their respective companies

Limitation of Liability

While reasonable efforts have been made to ensure the accuracy of this manual, the

manufacturer and distributor assume no liability resulting from errors or omissions in

this manual, or from the use of the information contained herein.

User’s Manual

Table of Contents

Chapter 1. General Information-------------------------------------------------------------5

1.1 Introduction---------------------------------------------------------------------------------5

1.2 Specification---------------------------------------------------------------------------------6

1.3 AW-A793 Package--------------------------------------------------------------------------7

1.4 Board Layout--------------------------------------------------------------------------------8

1.5 Board Dimension----------------------------------------------------------------------------9

Chapter 2. Connectors Location and Configuration-----------------------------------10

2.1 Connectors/Jumpers Location and Define-------------------------------------------10

2.2 Installing Processors----------------------------------------------------------------------12

2.3 Installing Memory-------------------------------------------------------------------------16

2.4 Connector and Jumpers Settings-------------------------------------------------------17

CN1:COM1 RJ45 Connnector-----------------------------------------------------------------17

CN2/3:Dual LAN (10/100) Connector------------------------------------------------------17

CN4:Dual LAN Gigabit Connector---------------------------------------------------17

CN5/13/14/16/17/32:FAN Connector----------------------------------------------------------18

CN6:COM2 Box Header--------------------------------------------------------------------18

CN7:LPT Pin Header----------------------------------------------------------------------18

CN8:+12V Power Connector--------------------------------------------------------------------18

CN9:GPI Pin Header-------------------------------------------------------------------------------18

CN10:Parallel Box Header------------------------------------------------------------------18

CN11:GPO Pin Header----------------------------------------------------------------------------19

CN12:ATX Power Connector ----------------------------------------------------------------19

CN15:IDE (2mm)44Pin 90 degree-------------------------------------------------------------19

CN19:Power LED Pin Header------------------------------------------------------------------19

CN20:HDD LED Pin Header--------------------------------------------------------------------20

CN21:PS-ON Pin Header------------------------------------------------------------------20

CN22:Reset Pin Header--------------------------------------------------------------------20

CN23/24/25/26/27/28/29/30:SFP Connector------------------------------------------------20

CN31:LCM back light Connector--------------------------------------------------------------20

JP2:PS-On/Always On Select------------------------------------------------------------------20

JP3:Clear CMOS------------------------------------------------------------------------------------20

JP4:CPU Frequency Select--------------------------------------------------------------------21

User’s Manual

Chapter 3. BIOS Setup-------------------------------------------------------------------------22

3.1 Quick Setup----------------------------------------------------------------------------------22

3.2 Entering the CMOS Setup Program----------------------------------------------------23

3.3 Menu Options--------------------------------------------------------------------------------24

Standard CMOS Features---------------------------------------------------------------------25

Advanced BIOS Features----------------------------------------------------------------------26

Advanced Chipset Features-------------------------------------------------------------------28

Integrated Peripherals--------------------------------------------------------------------------29

Power Management Setup---------------------------------------------------------------------30

PNP/PCI Configuration------------------------------------------------------------------------32

PC Health Status---------------------------------------------------------------------------------33

Load Fail-Safe Default--------------------------------------------------------------------------34

Load Optimized Default------------------------------------------------------------------------35

Set Supervisor & User Password-------------------------------------------------------------36

Chapter 4. Drivers and Utilities Installation-----------------------------------------------38

4.1 Ethernet Driver Installation --------------------------------------------------------------38

4.2 System Chipset Driver Installation------------------------------------------------------45

Appendix A. System resources---------------------------------------------------------------47

Appendix B. Optional Cable List--------------------------------------------------------------51

User’s Manual

Chapter 1. General Information

1.1Introduction

THE AW-A793 embedded control board based on Intel® architecture with

E7501+ICH3+P64H2 chipset supporting the Pentium® M processor with

400/533MHz FSB. The DDR 200/266 RAM (PC2100 registered) with ECC for

enhanced data integrity up to 8GB. It also integrates SafeXcel®-184x high

performance security co-processor onboard that designed for the VPN appliance

market and optimized for IPSec. The AW-A793 provides fourteen Ethernet ports

including eight GbE SFP pots, two GbE copper ports and four10/100BASE-T LAN

ports for multiple Ethernet port markets and performance requirements. SFP is a

new trend for networking application, the flexibility of GbE SFP port allow user to

choose either fiber or copper module according to their requirement.

Other features include a CompactFlash socket, right angle 64-bit PCI-X 100MHz

slot for future expansion capabilities, one IDE connector, two USB ports, two Serial

port, one Parallel port, digital I/O, watchdog timer and hardware system monitoring

for 1U chassis applications to give the customer a complete solution.

User’s Manual

1.2Specification

General Functions

CPU Intel Pentium® M based processors with 400/533MHz Front-side Bus

BIOS Award® 512KB Flash BIOS

Chipset Intel® E7501 + ICH3 + P64H2

I/O Chipset Winbond® 83627HF

Memory Onboard four 184-pin DDR DIMM socket, support PC266 registered

memory up to 8Gbytes

Enhanced IDE One IDE connector support up to two IDE devices

Serial port Two RS-232 ports, oneRJ-45 connector and one pin header

KB/Mouse

connector 5x2 header onboard support PC/AT Keyboard and PS/2 mouse

Parallel port One pin header for parallel port

USB connectors Two USB ports, one with pin header

PCI Slot One 64-bit PCI-X 100MHx

Watchdog Timer Can generate a system reset, Support software selectable timeout

interval.

System

Monitoring Support temp, fan speed and voltages monitoring

Digital I/O Support eight application definable LEDs

Ethernet Interface

Chipset Four Intel® 82551ER Fast Ethernet controller. Five Intel®82546GB

Fast Ethernet controller for eight Fiber & two GbE copper.

Ethernet interface PCI 10/100Mbps Ethernet controller, IEEE 802.3U protocol

compatible

SSD Interface One 50-pin CompactFlash™ socket

Mechanical and Environmental

Power supply voltage Standard ATX Power supply

Operating temperature 32 to 140 (0 to 60 )℉℃

Board size 11”(L) x 11”(W) , (275mmx275mm)

User’s Manual

1.3 Package

Please make sure that the following items have been included in the

package before installation.

1. AW-A793 Low Power Embedded SBC

2. Quick Setup

3. Cable: Please refer to Appendix B Optional Cables

4. CD-ROM which contains the following folders:

(1) Manual

(2) System Driver

(3) Ethernet Driver

(4) Tools

If any of these items are missing or damaged, please contact your

dealer from whom you purchased the board at once. Save the shipping

materials and carton in the event that you want to ship or store the

board in the future. After you unpack the board, inspect it to assure an

intact shipment. Do not apply power to the board if it appears to have

been damaged.

Leave the board in its original packing until you are ready to install

Precautions

Please make sure you properly ground yourself before handling the AW-A793 board

or other system components. Electrostatic discharge can be easily damage the

AW-A793 board.

Do not remove the anti-static packing until you are ready to install the AW-A793

board.

Ground yourself before removing any system component from it protective

anti-static packaging. To ground yourself, grasp the expansion slot covers or other

unpainted parts of the computer chassis.

Handle the AW-A793 board by its edges and avoid touching its component.

User’s Manual

1.4 Board Layout

User’s Manual

1.5 Board Dimension

User’s Manual

2005

Chapter 2. Connectors/Switch Location and Configuration

2.1 Connectors/Jumpers Location and Define

Indice

Altri manuali Aewin Technologies Hardware per computer

Aewin Technologies

Aewin Technologies AW-A795 Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente