2 1/15/2015 JPK
Installation
There are two mounting holes in each side of the rear panel. Mount the product on wall with appropriate screws.
Then, push left or right, if the equipment fixed vertically, or push down, if equipment fixed horizontally, to make it
fixed tighter. Installation now is completed.
Setup
1. The EoC receiver is a plug-and-play device. Connect an external AC to DC power adaptor (48VDC to 57VDC
output) to the power connector (2 pin terminal block) according to the polarity shown in the Power Connection
section. Then attach the plug into a standard AC outlet. The PWR LED will then be lit.
2. The READY LED will be lit (ON) when the receiver is ready for data transfer.
3. Connect one end of the coaxial cable to a female BNC connector (COAX DATA) on the ECR-4-PoE+ and the
other end to a transmitter (ECT-1-PoE+). If the transmitter and receiver are properly connected and
communicating with each other, the ACT will be lit (ON). The PoC LED will be lit too when the PoC is in use.
4. Connect the Ethernet cable from an NVR or PC or similar equipment to the Ethernet (10/100/1000Base-T) port.
If the cable is properly connected, the corresponding LED (100M or 1000M depending on the Ethernet
connection) at the RJ45 port with be lit. If there is data being transferred, the LED will be blinking.
Interface
