AFi PSR-2 Manuale utente
© Copyright 2008, American Fibertek, Inc. 1014JD
PSR-2 Power Supply
Instruction Manual
2
GRAPHICAL SYMBOLS
3
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
The PSR-2 is plug-in power supply unit for the SR-20 sub-rack frame. Utilizing state of the art,
low noise, switching power supply technology, it allows up to 100 Watts of output power to be
provided to the application cards. Over voltage and thermal protection are included in the unit.
There are no user serviceable parts inside. Up to fourteen single or seven dual position plug in
cards can be powered by the PSR-2
LINE VOLTAGE
For proper operation, the input line voltage should be in the range of 100 to 240 VAC, 50 - 60
Hz, properly grounded and conforming to all local codes. A universal power connector is
provided on the rear of the unit to facilitate connection to the power mains.
INSTALLATION
This installation should be made by a qualified service person and should conform to all local
codes. All wiring methods should be in accordance with the National Electric Code, ANSI/NFPA
70. The unit slides in and is locked into place by four ¼ turn fasteners. The line cord is then
plugged in from the rear. Be sure that the power switch is in the off (O) position before
connecting the power source.
The rear of the unit includes an exhaust fan. In order to insure long life and reliable operation,
air-flow from the fan port should not be obstructed.
4
POWER INDICATOR
A front panel LED indicates the AC line (POWER) being present and the power switch being in
the on (I) position. The ON/OFF switch is located on the rear of the unit. Be sure the switch is in
the off (O) position before connecting to the power source. Please note that this supply is
intended to be used with, and only when inserted into, an SR-20 sub-rack frame. Even though
the output connector is recessed, there is potential for high current at the output.
The sub-rack SR-20 is supplied with a three-conductor power cord. The Ground conductor is
directly connected to the chassis. See safety instructions.
LIFETIME WARRANTY INFORMATION
American Fibertek, Inc warrants that at the time of delivery the products delivered will be free of
defects in materials and workmanship. Defective products will be repaired or replaced at the
exclusive option of American Fibertek. A Return Material Authorization (RMA) number is
required to send the products back in case of return. All returns must be shipped prepaid. This
warranty is void if the products have been tampered with. This warranty shall be construed in
accordance with New Jersey law and the courts of New Jersey shall have exclusive jurisdiction
over this contract. EXCEPT FOR THE FOREGOING WARRANTY, THERE IS NO WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE,
EXPRESSED OR IMPLIED, WHICH EXTENDS BEYOND THE WARRANTY SET FORTH IN
THIS AGREEMENT. In any event, American Fibertek will not be responsible or liable for
contingent, consequential, or incidental damages. No agreement or understanding, expressed
or implied, except as set forth in this warranty, will be binding upon American Fibertek unless in
writing, signed by a duly authorized officer of American Fibertek.
SERVICE INFORMATION
There are no user serviceable parts inside the unit.
In the event that service is required to this unit, please direct all inquiries to:
American Fibertek, Inc. Phone: (877) 234-7200
120 Belmont Drive Phone: (732) 302-0660
Somerset, NJ 08873 FAX (732) 302-0667
E-mail: [email protected]
Indice
Altri manuali AFi Alimentazione elettrica
