6. Always chamfer the workpiece from left to right. Do not move the machine backward,
always move it forward.
7. Always start beveling from the edge of the workpiece. If you would like to start beveling
from the middle, you have to approach the machine to the workpiece very slowly to
prevent the damages on the insert tips.
8. The beveling speed depends on the beveling depth and beveling angles. (different beveling
quantity) It is recommended to adjust the beveling speed as per the beveling quantity. Do
not operate the machine with excessive speed.
9. It is recommended to replace the insert tips when they are worn, dull or damaged.
Excessive use may cause damages on cutter heads and the machine itself, thereby cause
shorter lifetime of the machine by the excessive power exerted on the machine.
13. When replacing the insert tips or doing repair works, be sure to separate the power cord
from the power source. In particular, never start operating the machine when the locking
bolt (List No. 13) is loosened and the frame (List No. 21) is separated.
14. When assembling parts of List No. 8, 9, 10, do it with 3mm hexagonal T-handle wrench as
illustrated below. At this time, turn the insert set screws continuously clockwise so that the
right-hand screws of the cutter body and the left-hand screws of the wedge could be
assembled together at the same time. When the inserts are completely assembled, adjust
the length of the left-hand screw or right-hand screw so that the head of the insert set
screws to be placed below the upper surface of the wedge.
For CP1000, set the inserts to be placed at the center of the cutter wedge.
For CP2100, set the inserts to be placed at the center of the two cutters facing each other.
10. Only 20 degrees insert tips should be used.
11. When replacing the insert tips, use 3mm
hexagonal T-handle wrench and tighten the
screw(Parts No.8) while pressing the tip
toward the center of the cutter, so that both
the bottom face of the tip and the seat of the
cutter are completely in contact.
12. When the screw (List No. 8) is not easily
loosened to replace the insert tips, do not
turn it with excessive power. Instead, loosen
the bolt (List No. 13), separate the whole
frame (List No. 21) and then loosen the jam
nut (List No. 11). After separating the cutter
(List No. 6), strike the insert tips with an
penetration screwdriver to remove them.
This makes the loosening work of the screws
easier to replace the insert tips.
Chamfer-Pro User’s Manual - 6 - AHA Industrial Co / www.ahaind.com
No.8 Screw
No.6 Cutter
No.11 Jam nut
