Airthereal FL-100H Manuale utente
USER MANUAL
READ AND SAVE THESE INSTRUCTIONS
FL-100H & FL-101S
FLOWLESS WATER LEAK DETECTOR
WITH WI-FI GATEWAY
CONTENTS
PRODUCT STRUCTURE DIAGRAM
SPECIFICATIONS
SET UP AND OPERATION
SET UP THE WATER LEAK DETECTOR
MODE CONTROL WITH AIRIA
SETTING MENU FOR THE GATEWAY
SETTING FOR WATER LEAK DETECTOR
BASIC SETTING AND INFORMATION SHARING
LOW BATTERY REMINDERS
LIMITED WARRANTY
················································02
············································································04
······························································05
········································13
························································19
···········································22
·····································23
···························30
··························································31
······································································32
2
PRODUCT STRUCTURE DIAGRAM
Wi-Fi Gateway
Warning Light
Power Indicator
Volume Tone
Setting
3
Water Leak Detector
Indicator
Sensor
Alarm Probe
AAA Battery
Test Key
Airthereal Water Leak Detector sounds an alarm after detecting water drips or leaks.
After connecting to Wi-Fi, it instantly sends alert notifications to the app wherever you are.
*433 is a communication protocol with a frequency of 433MHz.
Note: Obstacles or products of the same frequency (433MHz) will affect the reception
of information.
4
SPECIFICATIONS
Wi-Fi Gateway
Model: FL-100H
Power Supply: AC 100-240V, 50-60Hz
Battery: 450mAh 3.7V Li-ion
Alarm Volume: 120dB
Standby Time: 7h
Connect: 24 Detectors Max
Water Leak Detector
Model: FL-101S
Sensor Contact: Detect water drip
Sensor Contact: Detect water leak(0.5mm)
Test Button: Pause alarm / Adjust volume
Batteries: 2 x AAA Battery
Alarm Volume: 120dB
IP Waterproof Rating: IP66
Packing List
3 X Water leak detector
1 X Wi-Fi gateway
6 X AAA battery
1 X User manual
5
SET UP AND OPERATION
Wi-Fi Gateway
1. Power: Power on / off (Battery powered).
For AC power: The gateway will automatically turn on when connected to the power
supply. (When powered on, the Gateway will beep and the warning light will flash
once).
For Battery: The gateway will automatically charge when plugged into AC power.
(The power indicator changing from red to green means that the battery is fully
charged).
2. Tone: Short press to select different alarm sounds.
3. Volume: Short press to adjust the volume of the gateway. (4 levels of volume + mute,
default is the loudest setting).
Loudest levels: The warning light will flash twice, and the gateway will beep twice.
Mute: Warning light will flash twice.
6
4. Setting: Short press to adjust mode.
Please refer to page 10 for the specific introduction of each mode.
Mode
Armed
Disarmed
Home
SOS/Alert
Reaction
One beep sound
Two beeps sound
Three beeps sound
Can’t set
7
Checking the Water Leak Detector
Step 1 Install the battery
8
Step 2
Press the button [Test], and the detector will beep. Press again to pause the alarm.
Note: If there is no beep, open the back cover to check whether the positive and
negative directions of the battery are installed correctly.
Press the button once.
9
Step 3
Adjust alarm volume by pressing and holding the test button for 3 seconds.
Press and hold for 3s each time to adjust one level of volume.
Long press the button 3s.
4 (DiDiDiDi-maximum sound)
3 (DiDiDi)
2 (DiDi)
1 (Di-mute)
Questo manuale è adatto per i seguenti modelli
1
Indice
