Aleratec 260206 Manuale utente
®
USER GUIDE
Aleratec 1:15 Blu-ray/DVD/CD
Tower Duplicator SA™
Part No. 260206
www.aleratec.com
Copyright/Model Identification
The content of this manual is for informational purposes only and is subject to
change without notice.
This manual is copyright with all rights reserved. Under copyright laws, this manual
and the software described within may not be copied, except in the normal use of the
product(s) described within or to make a backup copy.
Copyright© 2012
Aleratec, Inc.
9851 Owensmouth Avenue
Chatsworth, CA 91311 U.S.A.
Aleratec® is a registered trademark, and 1:15 Blu-ray/DVD/CD Tower Duplicator
SA™ is a trademark of Aleratec, Inc
Check out Aleratec Online!
• Blog.Aleratec.com
• Facebook.com/Aleratec
• Twitter.com/Aleratec
• YouTube.com/Aleratec
Please record the following information to help expedite any warranty claim:
Model No. _________________________ Serial No.________________________
Date Purchased _______________________________________________________
Place of Purchase _____________________________________________________
www.aleratec.com
Radio/TV Interference Statement
The equipment described in this guide emits radio frequency energy. If it is
not installed in accordance with the manufacturer’s instructions, it may cause
interference with radio or television reception.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instruction manual, this equipment may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be veried
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an electrical outlet on a circuit that is different from
the circuit to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
This equipment has been certied to comply with the limits for a Class B computing
device, pursuant to FCC Rules. In order to maintain compliance with FCC
regulations, shielded cables must be used with this equipment. Operation with non-
approved equipment or unshielded cables is likely to result in interference to radio
and TV reception. The user is cautioned that changes and/or modications made to
this equipment, without the approval of manufacturer, could void the user’s authority
to operate this equipment.
www.aleratec.com
Safety Regulations
WARNING
To prevent re or shock hazard, do not expose the unit
to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to authorized personnel only.
CAUTION
As the laser beam in these 1:15 Blu-ray/DVD/CD
Tower Duplicator SA is harmful to the eyes, do not
attempt to disassemble the cabinet. Refer servicing to
authorized personnel only.
The use of optical instruments with this product will
increase eye hazard.
This BD/DVD/CD Duplicator is classied as a CLASS
1 LASER PRODUCT.
The CLASS 1 LASER PRODUCT label is located on
top of the internal drive enclosure.
CLASS 1
LASER PRODUCT
LASER KLASSE 1
PRODUKT
www.aleratec.com
Table of Contents
Introduction ...................................................................................................1
Product Features ...................................................................................................1
Key Items – 1:15 Blu-ray/DVD/CD Tower Duplicator SA .................................2
1:15 Blu-ray/DVD/CD Tower Duplicator SA: LCD Front Panel ........................3
1:15 Blu-ray/DVD/CD Tower Duplicator SA: Removable Hard Disk Drive ...........4
Precautions ...................................................................................................5
Before you start: ...................................................................................................5
Overview ........................................................................................................7
Unpacking the Unit ..............................................................................................7
Connect the Cables and Apply Power ..................................................................7
Control Functions.................................................................................................8
Tower Duplicator SA: Tutorials ...................................................................9
Making Disc-to-Disc Copies ................................................................................9
Load Source Files onto the Hard Drive .............................................................14
Load Master Disc onto the Hard Drive ..............................................................16
Rename Existing Hard Drive Partition Name ....................................................20
Delete Existing Hard Drive Partition Permanently ............................................22
Choose Hard Drive Partition Display Order ......................................................24
How to Make Copies from the Hard Drive ........................................................26
Select Burn Speed ..............................................................................................31
Select the Source drive .......................................................................................33
Change the SETUP Settings ..............................................................................35
Audio CD Editing ..............................................................................................36
Introduction to Manage Accounts .....................................................................44
Manage Accounts: Overview .............................................................................46
Introduction to Duplication Mode .....................................................................48
Using AUTOCOPY ............................................................................................51
Menu Overview ...........................................................................................53
Troubleshooting .........................................................................................60
Recommended Media ................................................................................64
Technical Support ......................................................................................65
Service and Support ...................................................................................66
Technical Support FAX Back Form ...........................................................69
www.aleratec.com
®
www.aleratec.com 1
Introduction
Thank you for purchasing the 1:15 Blu-ray/DVD/CD Tower Duplicator SA. Please
read this User Guide thoroughly before using this product.
Product Features
The Aleratec 1:15 Blu-ray/DVD/CD Tower Duplicator SA is a stand alone disc
duplication system with the capability of simultaneously producing up to 15 BD/
DVD/CD copies, and no computer is required.
• Removable Hard Disk Drive to store disc images.
• Aleratec only USB fast key instantly connects Hard Drive to a PC.
• USB 3.0/2.0 connection for fast loading of image les from a PC.
• Duplicate from ISO image les, NRG image les, or even directories and les
not packaged into a disc image le*
* Duplicating from folders on the Duplicator HDD is only supported for CDs and DVDs.
www.aleratec.com
2
Introduction
Key Items – 1:15 Blu-ray/DVD/CD Tower Duplicator SA
LCD Control PanelRemovable
Hard Disk Drive
(see page 4)
BD/DVD/CD Source
and RW Drive
BD/DVD/CD
RW Drives*
www.aleratec.com 3
Introduction
1:15 Blu-ray/DVD/CD Tower Duplicator SA: LCD Control Panel
(View may vary from picture)
1. Display shows all functions and messages
2. ESC button is used to cancel a selected function
3. ENT button is used to execute a selected function
4. COPYbutton will start the “Autocopy” menu function. (See page 59 for more
information)
5. USB button will take you directly to the USB On/Off mode option. (See page
65 for more information)
6. PRESCANbutton allows you to scan and detect any bad sectors existing in the
Master Disc.
7. SOURCE button will allow you to change the Source drive that the duplicator
uses for loading Master Discs. The default for this option is the BD/DVD/CD
source drive. (See page 33 for more information)
8. UP arrow is used to scroll up through functions or menus
9. DOWN arrow is used to scroll down through functions or menus
ESC
Initialize Duplicator
1-15 ver: X.XX
8
13
9
2
ENT
COPY USB SOURCEPRESCAN
4 5 6 7
www.aleratec.com
4
Introduction
1:15 Blu-ray/DVD/CD Tower Duplicator SA: Removable Hard
Disk Drive
Your Duplicator SA is equipped with a removable hard disk drive (HDD) for storing
images of frequently copied discs. Storing an image of a disc you want to copy on
an HDD improves duplication speed, and adds the convenience of not having to look
around for the actual source disc you want to copy.
Your removable HDD provides extra security, in that you can remove the drive
containing the disc images and put it in a safe place where non-authorized users can
copy or view the data.
The removable HDD includes a keyed lock to protect the data on the drive from being
misused or stolen. The HDD is used in the copy process as described in the following
pages of this user guide.
Note: You can use the duplicator to copy directly from BD, DVDs or CDs with
or without the HDD. Just place your source disc in the BD/DVD/CD source
drive or any of the BD/DVDRW writers.
To remove the HDD:
1. Unlock the HDD by inserting the key and turning it left (counterclockwise) 1/4
turn. The drive is now in the unlocked position.
2. Lift the HDD carriage lever upward and pull out. The HDD carriage will come
out of the tower and a protective drive bay door will close.
To replace the HDD:
1. Align the HDD carriage with the door opening and push the drive carriage
through the protective drive bay door until you feel the drive seat in its connector.
2. Push the HDD carriage lever down, then insert your key and turn it 1/4 turn to
the right (clockwise). The HDD is now in its locked position. You can remove
the key.
Note: The HDD will not work unless it is secured in position with the carriage
lever and locked with the key. Do not unlock the HDD during operation, as you
will destroy any copies you are making.
Removable Hard Disk
Drive
Key in Lock
Carriage Lever
Altri manuali per 260206
1
Indice
Altri manuali Aleratec Hardware per computer
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
