UH118 P162 PIR Mobility Detector Wired page 3 of 8 UH118 P162 PIR Mobility Detector Wired page 3 of 8
Installation
Location:
ŸThe unit has a horizontal window covering approximately 1.5 meters (the
length of a bed) from a distance of 1.5 meters. It also has a narrow vertical win-
dow (±20 cm from the base) at this point. Hence if positioned on the floor
pointing at a bedside, at a distance of 1.5-2.5m, it will detect feet descending to
the floor, while being immune to body movement in bed. This makes it ideal
for monitoring bed vacation,
ŸIf positioned on furniture or wall mounted using the bracket supplied, at a
height of approx. 50 cm above the bed height with a clear view of the bed, it
will detect someone sitting up while being immune to normal movement
around the bed.
ŸIf positioned viewing a door or on a corridor wall at body height it will operate
when someone comes into view, but can be immune to pets etc at floor height.
The range is up to 5 metres.
ŸIt can also be mounted centrally above a door, pointing down. It will then
alarm if someone passes through the doorway., but not if they are further away
than a typical door mat.
To ensure reliable operation it is essential to ensure that there are no sources of
rapid heat change within the viewed area. Such sources could be radiators,
windows, dangling decorations, bathroom doors
Securing
The bracket supplied should be used to secure the main unit to a wall or other fix-
ture. Screws and wall plugs are supplied
Connecting to Nurse Call:
The unit will be supplied with a connector to mate with any specified Nurse Call.
This is often supplied as a an extension lead to the standard RJ22 Female connector,
using the normally open or closed contact as necessary. Plug the unit into the wall
socket, replacing any call button. Alert-iT can supply “splitter adapters” that allow
the call button to be used along with P162.
Pairing the Keyfob
After first enabling the battery power, or following battery replacement, the
supplied keyfob has to be paired with the main unit by pressing ARM while
pointed at the front. The red led should flash and pairing is complete.
