
4
INSTALLATION
The Allspace Wall Organization System was created to give you the amount of organization you need in whatever size space
you have. Change that bare wall in the garage into rows of easily found tools. Store household items in that space above the
washer. Keep office supplies handy by hanging a single square of pegboard in your home office. Allspace can fit in almost
any space to serve almost any need.
The sturdy steel construction is strong enough to hang bicycles and ladders, but the plastic hooks and baskets allow you to
hang up the smallest tools or fasteners. Each pegboard panel, properly assembled, has a capacity of 75 lbs.
This system is designed for both stud mount or 5/8 in. or thicker wallboard anchor
mount. DO NOT USE wallboard anchors on wallboard that is 1/2 in. or less.
UNPACKING
Remove all materials from the box. Make sure all the parts needed for assembly are included. Check that there are no sharp
edges or burrs that could injure you during assembly. Set all the plastic hanging hooks and baskets aside. You will not need
them until after the wall has been assembled.
PREPARING THE LOCATION
Know the location of all utility lines before drilling. Serious injury or even death
may occur if you accidently drill into a utility connection.
Now you need to decide where you want your pegboard to go. Make
sure the space you have chosen is a flat wall that is clean and free of
obstacles or obstructions.
Using a stud finder, locate the studs in your chosen wall. Studs are
vertical pieces of wood that are usually about 16 inches apart. Once
you have found the first one, move 16 inches horizontally to find the
next one. Mark the stud locations on the wall with pencil. Use a level to
make sure the pencil marks are in a straight line.
Hold one of the top tracks up against the wall, making sure that the
first hole in the track lines up with the first pencil mark. Note where
the second pencil mark falls. (Sometimes the holes in the metal tracks
will not line up with the studs. In those cases, you will have to use
wallboard anchor screws.)
Continue across the wall, marking all the hole locations. For wall mounts requiring 4 peg panels horizontally, you will need
to add utility tracks (450036-01) on each side of two top tracks (450036-02). Both top tracks should be mounted first, then
mount the utility tracks. The top track is slightly longer than the utility track and the drilling locations will need to be adjusted
accordingly. Drill holes in the wall at all the marked locations. If the location does not line up with a stud, you will have to
insert a wallboard anchor into the drill hole. (For stud mount, drill 1/8 in. holes, for wallboard mount, drill 5/16 in. holes.)
This will prevent the screw from pulling out of the wall when you attach the track.
16in
407mm
To prevent injury and/or property damage, DO NOT USE if any part is
missing or damaged.