Alpha Alpha CD Condensing Boiler Manuale utente

Installation Instructions

Alpha CD Condensing Boiler

CDVertical FlueTerminal Assembly

Concentric (60/100) Flue System

(Kit Part No. 6.2000520)

KIT CONTENTS

1. GENERAL

Note: The CD Vertical flue terminal MUST ONLY be used with an Alpha CD condensing boiler.

a. The flue system must be installed in accordance with BS 5440:1;1990.

b. The boiler must be installed in accordance with the Installation instructions supplied with the CD boiler.

c. The vertical flue terminal assembly is equivalent to a 1 m length of flue.

d. Each 45° bend is equivalent to a 0.9 m length of flue.

Note: A 90° bend must not be used with the vertical flue.

e. Refer to the vertical flue options (Fig. 3) and ensure the flue length does not exceed the equivalent of 15 m

(including the terminal assembly).

f. Additional flue lengths of 0.75 m (CD flue extension, Part No. 6.2000750) are available for extending the flue up to a

maximum equivalent flue length of 15 m (including the terminal assembly).

g. The CD vertical flue terminal assembly may be connected directly to

the boiler adaptor. However, under no circumstances must it be

shortened.

h. To determine the actual length of flue required (L), measure the

distance from the top of the side panel to the weathering slate position

and subtract 640 mm for the terminal assembly, i.e. L = A - 640 mm

(see Fig. 3).

2. INSTALLATION

a. When the template is on the wall in the boiler position, continue the

vertical line from the centre of the flue hole to the roof/ceiling position.

Mark the centre position of the flue hole 165 mm from this line as

shown in Fig. 1.

b. Cut a hole and/or remove tiles so that there is at least a 150 mm

diameter hole in the roof. Ensure there is at least a 25 mm gap

between the outer duct and any combustible material. Fig. 1

Compiled and designed by Publications 2000, Tel (01670) 356211 11/03/D155

Fig. 3

c. Fit a 125 mm diameter weathering slate over the hole in

the roof. A suitable weathering slate (Part No.

6.1000380) is available from Alpha Therm Ltd.

d. Position the vertical terminal assembly into the

weathering slate ensuring that the slate is located under

the lip of the terminal as shown in Fig. 2.

Note: Ensure that the minimum distances are maintained

(see Fig. 3). Do not secure the terminal into position at

this stage.

e. Assemble the flue extensions together by locating the

inner duct into the seal joint and secure each extension

together with the clamps supplied (three screws). Ensure

that the clamps are positioned centrally over the joints.

Note: If it is required to cut an extension, DO NOT cut

the end of the inner duct that incorporates the seal joint.

Ensure the inner duct end without the seal joint is cut so

that it is 15 mm longer than the outer duct.

f. Connect the vertical terminal ducts to the flue assembly,

as shown in Fig. 2. Secure with the outer duct clamp

(three screws).

g. After assembling all of the ducts, check that the terminal

is correctly located above the roof.

Note: Ensure that the flue assembly is supported at roof

level using suitable brackets, and that the weathering

slate is fitted correctly. Fig. 2

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

NepicarHouse,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001964

email: [email protected]

website: www.alpha-boilers.com

Indice

Altri manuali Alpha Caldaia

Alpha

Alpha Alpha CombiMax 350 Guida utente

Alpha

Alpha InTec 40GS2 Guida utente

Alpha

Alpha ARES 440 Tec Guida utente

Alpha

Alpha CB28X Manuale di servizio

Alpha

Alpha Alpha 500E Manuale utente

Alpha

Alpha Alpha CombiMax 350 Foglio di istruzioni

Alpha

Alpha Alpha CD50 Manuale utente

Alpha

Alpha Alpha 240X Manuale utente

Alpha

Alpha Alpha CB Boiler Manuale utente

Alpha

Alpha 240eco Manuale utente

Alpha

Alpha ARES 440 Tec Guida utente

Alpha

Alpha Alpha CD13R Manuale utente

Alpha

Alpha CD90S Guida utente

Alpha

Alpha Alpha CB Boilers Manuale utente

Alpha

Alpha Alpha Twin Pipe Flue Systems Manuale utente

Alpha

Alpha E-Tec Plus 28 Guida utente

Alpha

Alpha 41 532 05 Guida utente

Alpha

Alpha Alpha CB24 Manuale utente

Alpha

Alpha Alpha CB50 Boiler Guida utente

Alpha

Alpha GasSaver GS-1 Guida utente

Alpha

Alpha ARES Pro 150 Guida utente

Alpha

Alpha E-Tec 28 Manuale utente

Alpha

Alpha Alpha CD50S Guida utente

Alpha

Alpha Alpha HE25 Manuale utente

Manuali Caldaia popolari di altre marche

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manuale utente

Radijator

Radijator BIO max 23.1 Manuale utente

Brunner

Brunner BSV 20 Manuale utente

Buderus

Buderus Logamax GB062-24 KDE H V2 Manuale utente

Potterton

Potterton 50e Scheda tecnica

UTICA BOILERS

UTICA BOILERS TriFire Manuale utente

Joannes

Joannes LADY Series Manuale

ECR International

ECR International UB90-125 Manuale di istruzioni

Froling

Froling FHG Turbo 3000 Manuale utente

Froling

Froling P4 Pellet 8 - 105 Manuale utente

U.S. Boiler Company

U.S. Boiler Company K2 Manuale utente

Henrad

Henrad C95 FF Manuale utente

NeOvo

NeOvo EcoNox EF 36 Manuale utente

Potterton

Potterton PROMAX SL 12 Manuale utente

Eco Hometec

Eco Hometec EC 25 COMPACT Manuale utente

Viessmann

Viessmann VITODENS 200 Guida

Baxi

Baxi Prime 1.24 Manuale utente

REXNOVA

REXNOVA ISA 20 BITHERMAL Manuale utente