Altelix HN-0006 Manuale utente
The HN-0006 comes pre-configured for use in the NS series enclosure. The
second lock cam included is not needed for this installation.
Step 1
Remove the existing latch by removing the retaining nut.
HN-0006 Installation GuidePage-1Page-4
IS0158 Rev A 01/27/20
Altelix LLC USA:866-660-WIFI (9434) International: +1 561-660-9434 sales@altelix.com www.altelix.com
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix andthe Altelix logo are Trademarks and/or RegisteredTrademarks of Altelix LLC.
Specificationsare subjectto change without notice. See www.altelix.com for most current information
The HN-0006 is for use with Altelix NS series and NFC series enclosures. It is a
direct replacement for the standard latch included with these enclosures.
Padlock Latch with Retaining Nut
and Lock Cam for use with NS
Series enclosures
Handle Padlock Latch for NS/NFC Series Enclosures
Got Questions?
We are here to help.
Contact us at:
sales@altelix.com
USA & Canada Customers: 866-660-9434
International Customers: +1 561-660-9434
What’s In The Bag?
Lock Cam for use with NFC Series
enclosures.
NS Series Steel Enclosure Installation
Remove Retaining Nut
Securing the Enclosure
Turn the Padlock Latch until the enclosure door is securely closed. Then
attach a padlock (not included) as shown.
The HN-0006 will accept padlocks with shackles/shanks ranging from 6mm
to 8mm in diameter.
Also available to secure the NS and NFC series
enclosure is the HN-0005 Keyed Lock Set. For
more information visit www.ALTELIX.com
HN-0005 Keyed Lock Set
HN-0006 Installation Guide
Page-3Page-2
Step 2
Remove retaining nut from Padlock Latch and install into enclosure door.
Orientate the latch as shown. Secure Padlock latch with retaining nut.
Front of Enclosure Door Inside of Enclosure Door
Step 1
Remove the existing latch by first removing the lock cam. Then the
retaining nut can be removed.
Do not discard the nylon washer, it will be reused.
NFC Series FRP Enclosure Installation
Remove Retaining Nut
Nylon Washer
Step 2
Remove retaining nut from Padlock Latch and install into enclosure door.
Orientate the latch as shown. Replace the nylon washer and secure
Padlock latch with retaining nut.
Remove Lock Cam
Front of Enclosure Door Inside of Enclosure Door
Step 3
Once Padlock Latch is secured, remove the lock cam which is for use with
the NS series enclosures only. This will be replaced with the second lock
cam included in the bag.
Step 4
Install the NFC enclosure lock cam as shown.
Remove NS Enclosure Lock Cam Install NFC Enclosure Lock Cam
Once installed, test Padlock Latch to ensure proper operation.
Once installed, test Padlock Latch to ensure proper operation.
HN-0006 Installation GuideHN-0006 Installation Guide
Altri manuali Altelix Serratura
