4
Before First Use
Check for transport damage.
Risk of suffocation! Keep any packaging materials away from children – these materials are a potential
source of danger, e.g. suffocation.
Installation
Step 1:
Shut Off Water Supply
• Locate water supply inlets and shut off the water supply
valves. These are usually found under the sink or near
the water meter. If you are replacing an existing faucet,
remove the old faucet from the sink and remove any dirt
and/or plumber’s putty from around the faucet holes.
Step 2:
Setup
Rubber
o-ring (D)
Rubber
o-ring (D)
One (1) Hole Sink Three (3) Hole Sink
Base plate
gasket (H) Base plate (G)
For 1-Hole Installation
• Remove mounting nut (K), metal washer (J) and
rubber washer (I) from threaded pipe (T).
Make sure the rubber o-ring (D) is at the
bottom of the faucet body before proceeding.
• Slide the hoses, pipes and threaded pipe through the
hole in the sink.
For 3-Hole Installation
• Remove mounting nut (K), metal washer (J) and
rubber washer (I) from threaded pipe (T).
Make sure the rubber o-ring (D) is at the
bottom of the faucet body before proceeding.
• Make sure the deck plate gasket (H) is inserted into the
deck plate (G).
• Position the deck plate (G) over the 3 holes in the sink.
• Slide the hoses, pipes and threaded pipe through the
deck plate (G), deck plate gasket (H) and the center hole
of the sink.
Step 3:
Mount in Place
Rubber washer (I)
Threaded pipe (T)
Metal c-shaped
washer (J)
Mounting nut (K) • Slide the rubber washer (I), metal c-shaped washer (J),
over the water lines and onto the threaded pipe (T).
• Screw the mounting nut (K) onto the threaded pipe (T)
and hand-tighten.
Make sure the faucet or base plate (G) is
centered over the sink hole(s) and then finish tightening the
mounting nut (K) by hand.
DANGER
NOTICE
NOTICE
NOTICE
