Copyright©2016 A & H Enterprises, Inc.
All rights reserved
00000329-0900-014 * Rev. B, 06/16
ELECTRICAL SET-UP: Actuator Board
Both power cable and HART cable must be connected.
First, remove the electrical panel cover by loosening the four (4) screws
on the electrical box and removing the panel. Be careful not to lose the
screws.
ACTUATOR WIRING: HART
1. Connect 24VDC Power to Terminal Block 1.
2. Connect Ground to Terminal Block 2.
3. Connect the positive side of the HART cable to Terminal Block 8.
4. Connect the negative side of the HART cable to Terminal Block 9.
Terminal block wiring reference for field connections
WARNING
Incorrect wiring may
damage the unit!
