3. Assemble the remaining hardware for the
Bulletin 095265-000 • Revision K • January 2010 • Page 2 of 2
Andrew Corporation
DB800TREEKIT dB TripleTree™ Mounting Kit
NOTICE
Richardson, TX U.S.A. 75082
2601 Telecom Parkway
Base Station Antennas
Internet: www.andrew.com
FAX (U.S.A.): 1-800-229-4706
Telephone: 1-800-676-5342
Other Europe: +44 1592 782612
U.K.: 0800 250055
Copyright . 2004 by Andrew Corporation
Printed in U.S.A.
Customer Service, 24 Hour: U.S.A. • Canada • Mexico: 1-800-255-1479
Andrew Corporation
The installation, maintenance, or removal of an antenna
to 3 1/2” (88.9 mm) O.D. max.
nnas measuring 1 1/4” (31.8 mm) min.
location. The clamp will fit omni ante-
where specifically marked for a clamp
Clamp the jaws on the omni antenna
requires qualified, experienced personnel. Andrew inst-
allation instructions are written for such installation per-
sonnel. Antenna systems should be inspected once a
year by qualified personnel to verify proper installation,
maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the
results of improper or unsafe installation practices.
clamps.
5. Repeat steps 2 through 4 for additional
mounting clamp as shown in Figure 1. For
a torque of 45 ft-lbs.
All hex nuts (Item 5) should be tightened to
should be tightened to a torque of 55 ft-lbs.
4. The square nut (Item 7) on the threaded rod
threaded rod (Item 6) will allow.
(Item 9) as the nut on the end of the
alled as close to the modified bracket
stability, the clamp (Item 1) should be inst-
INSTALLATION INSTRUCTIONS
1. Determine the location where the clamps
will be attached to the mounting structure.
(Antennas are marked to show location to
place mounting clamp.) Carefully drill two
5/8” (15.88mm) holes in the mounting str-
ucture (one for the upper clamp and
another for the lower clamp).
2. Insert the threaded rod (Item 6) through the
modified bracket (Item 9). Install the subas-
sembly onto the pole or wall using the
square nut and washer (Items 7 and 8).
