ENGLISH
START 8 Series | User manual
8
9
User manual | START 8 Series
Series
After choosing the desired channel, press the ASC button, place the beltpack
transmitter close to the IR window of START 8R receiver and wait for the selected
channel to stop flashing on the handset display. After the synchronization, the
receiver's display is lit steadily on the selected channel (frequency).
4 MINI XLR-M INPUT
Connected to this input the supplied PH-30 Headset or the signal of other sound
sources.
5 POWER ON AND LOW BATT
Green light: Transmitter on, charged batteries
Red light steady: Immediately replace the batteries.
6 GAIN SELECTOR
There are three different gain settings:
Mic: for supplied headset microphone and other microphones
0 dB: low output level instruments
-10dB: high output level instruments
7 BATTERIES COMPARTMENT
To replace the batteries, lightly press on the sides of the cover and lift forward. Take
out the old batteries, and insert two new batteries (respecting the compartment
icons) then close the lid. Remove the batteries from the receiver when not in use
for extended periods.
WEARING THE BELTPACK RECEIVER:
Clip the receiver to a belt or to
the shoulder strap of your guitar.
For better fastening reliability it's
preferable to secure it as shown in
the gure, then fasten it in a way
that the belt is tight from the clip..
3 | TIPS FOR BETTER USE OF THE SYSTEM
• Aim the transmitter to the receiver to achieve a “direct visual contact” between
devices, without any interposed obstacle.
• For correct operation, the antennas must be completely extended and inclined 45°
outwards. Never cover the antenna during use.
• Avoid placing the receiver near metal objects/surfaces or close to digital
equipment (CD players, computers, etc.).
• Place the receiver in such a way that is far from a wall and that is at least
1 meter (about 3 feet) above the floor.
• Cell phones, two-way radio equipment or similar devices may disturb
the radio transmission between the transmitter and the receiver, so they
should not be used close to the transmission system.
4| TROUBLESHOOTING
PROBLEM LEDS SOLUTION
No sound or very low
sound level Receiver ON/OFF
LED turned off. Make sure the unit is properly
connected
Power LED turned
off. Make sure the power supply is
properly connected to the receiver
Receiver RF LED
turned on.
Raise the volume.
Raise transmitter gain.
Check the connections between
the receiver and the amplier or the
mixer.
Receiver RF LED
turned on.
Transmitter LED
turned on.
Don't place the receiver close to
metallic objects.
Check that the transmission
space ("visual contact") between
transmitter and receiver is free.
Approached the transmitter to the
receiver.
Make sure the transmitter and
receiver share the same frequency.
Batteries status LED
is red. Replace batteries.
Distortion or unwanted
interferences. Receiver RF LED
turned on.
Remove possible sources of
interference such as CD players,
computers, digital broadcast sources,
etc.
Increasing distortions, Batteries status LED
is red. Replace batteries.
Great intensity difference
when the same source
is via cable, or in case of
connection with other
guitars or microphones.
Set properly the transmitter gain
selector and the receiver volume.
