Apogee JAM Manuale utente
QuickStart Guide
Plug JAM into your iPad using the provided iPad dock cable
Plug your guitar into JAM’s 1/4” input
Plug your headphones into iPad’s headphone output or just listen through iPad’s built-in speakers
Click the Record button and you are recording with JAM!
Using JAM with an iPad
Start up GarageBand and choose New Song
(JAM’s status light should turn to green)
Choose Guitar Amp
To hear your track, turn Monitor ON by clicking and following instructions
Check the status light on JAM, it should be Blue
Blue - JAM is connected but not ready
Green - JAM is connected, ready and
working with your software
Red - Your gain is too high, adjust
the gain using the Gain Control Knob
on the side of JAM
Plug JAM into your Mac using the provided USB cable
Plug your guitar into JAM’s 1/4” input
Start up GarageBand, Choose New Project > Electric Guitar
(JAM’s status light should turn to green)
Name the Project and save it on your hard drive
Go to GarageBand > Preferences > Audio/Midi >
Choose JAM for Audio Input
Choose Built-In Output for Audio Output
Plug your headphones into your Mac’s headphone
output or just listen through your Mac’s built-in speakers
To hear your track in GarageBand, click to turn monitoring on
Click the Record button and you are recording with JAM!
Using JAM with a Mac
Check the status light on JAM, it should be Blue
Blue - JAM is connected but not ready
Green - JAM is connected, ready and
working with your software
Red - Your gain is too high, adjust
the gain using the Gain Control Knob
on the side of JAM
For FAQs and more JAM support information,
please visit the Apogee Website:
http://support.apogeedigital.com/
Apogee Electronics Corporation
1715 Berkeley St.
Santa Monica, CA 90404 U.S.A.
00+1 310-584-9394
Indice
Altri manuali Apogee Accessori per computer
