APT 29704 Manuale utente
A
ir
cooler
Æ
ev
22
11
INDEX:
GB............................................................................................. 1:
NO........................................................................................... 11.
SE............................................................................................. 21.
FI..............................................................................................31.
DK............................................................................................41.
Safety instructions........................................(See separate folder)
Unpacking
Remove all items from the packaging. Retain the packaging. If you dispose of it please do so
according to local regulations.
The following items are included:
Air Cooler /
Tower Air Cooler
Instruction Manual
Instruction
Manual
Remote Control Screw × 4
Base plate × 2 Ice box × 2
Air Cooler
Air Cooler
1
Assembling Your Fan
• Avoid using your fan in hazardous areas.
• Do not use your fan if it has not been fully assembled. Make sure that the base
clip that hold the base parts and the main unit together are tightened securely.
• Do not connect the unit to the mains until the assembly is nished.
1. Assemble the base plates.
2. Turn the base upside down.
3. Release the screws from the bottom of the tower fan. Fix the bottom part of the unit
onto the base. Tighten the screws to secure the unit.
2
4. Turn the water tank switch at the rear of the unit anticlockwise. Slide the water tank out
from the unit.
5. Pour water (not over the max level) and place the ice box(es) into the water tank. Slide
the water tank back to the unit, and turn the water tank switch upward to lock the water
tank securely.
6. Connect the mains plug to the mains socket. The unit will prompt a beep sound, and all
the indicators will light up once to indicate that the unit is now in Standby mode.
3
Product Overview
Main Unit Remote Control
5
41
2
3
1. Button
2. Mode Button
3. +/– Button
Press to increase/decrease wind
speed.
4. On/O Button
5. Timer Button
1
2
3
1. Control Panel
2. Sensor
3. Base
4
Control Panel
COOLER TIMER MODE SPEED OSC
4
5
6
7
1
9
8
10
11
12
13
2
3
1. Sleep Wind Mode Indicator
2. Timer 1h / 2h / 4h Indicator
3. COOLER Indicator
• Light up in Cooler mode
• Flash while water shortage in water tank
4. Baby Wind Mode Indicator
5. COOLER Button
6. TIMER Button
7. On/O Button
8. / / Wind Speed Indicator
9. Ioniser Indicator
10. Oscillation Indicator
11. SPEED Button
12. OSC Button
13. MODE Button
5
Installing Batteries in the Remote Control
1. Slide to open the battery compartment cover
of the remote control.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage,
which could cause re, personal injury or damage to property.
• Only use the battery type indicated in this manual.
• When the batteries are exhausted, the remote control will not function.
Replace both batteries at the same time with new ones.
• Do not install new batteries with used ones and do not mix dierent types of
batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in
accordance with local regulations.
Handling the Remote Control
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of
excessive heat.
• Remove the battery from the remote control when not in use for a long
period of time, as it could cause corrosion or battery leakage and may result in
physical injury and/or property damage including re.
2. Insert two AAA size batteries (not included).
Make sure to match the (+) and ( - ) ends of the
batteries with the (+) and ( - ) ends indicated in
the battery compartment.
3. Close the battery compartment cover.
6
How to Use Your Fan
When using the remote control, make sure it is pointed towards the fan.
Powering On/O
Press the On/O Button on the unit or Button on the remote control to switch the unit
on or o.
Selecting Modes
Press the Mode Button repeatedly on the remote control to select the wind mode:
normal, Sleep Wind Mode (Fan speed: - Low, - Medium), Baby Wind Mode (Low
Wind mode).
Cooler Mode
Press the COOLER Button on the unit to switch COOLER mode on or o.
Timer Settings
Press the TIMER Button on the unit or Button on the remote control repeatedly to set
the timer from 1 to 7 hours (press once to increase 1 hour).
Wind Speed Settings
Press the Speed Button on the unit to adjust the fan speed ( - Low, - Medium, -
High).
Oscillation
Press OSC Button on the unit or Button on the unit or remote control repeatedly to
allow or stop the fan head rotating from side to side.
Cleaning
Unplug the unit from the mains socket.
Use a slightly damp cloth to wipe the outer body of the unit. Never completely cover the
unit with water or use chemicals or detergents as they could damage the unit.
To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of
dust. Do not disassemble the fan for cleaning.
7
Cleaning the lter of water tank
1. Slide the water tank out from the unit. Turn the rotary knob 90° anticlockwise to unlock
the water pump module.
It is recommended that the water pump should be cleaned every 3 months.
2. Take out the water pump module, remove the lter and start cleaning.
3. After cleaning, install the water pump module back to the water tank. Turn the rotary
knob 90° clockwise to lock the water pump module. Slide the water tank back to the
unit, and lock the water tank securely.
Remove the lter
8
Indice
Lingue:
