Water
Supply
Eliminate
particulate matter
(copper & brass
filings) before
connecting
to unit.
Water
Inlet
We recommended to
Installing Isolation Valve
on Water Inlet (not
supplied) externally for
easy maintenance.
DON’T Install S-Trap
below the pod !!
S -TrapIsolation Valve
Pod has its own
in-built S-Trap
Flush out the lines
3
2
4
DON’T FORGET
Seal all plumbing
Apply sealant to
T-junction pipe
ends before
inserting them
into other pipes
Check for leaks
Run taps and
adjust any
insecure
connections
SET UP FOR USE
Run the tap
Adjust water pressure
Rotate keyhole with a
5mm screwdriver to
adjust water pressure
until the pod is full
Advise client to check
water pressure 48 hours
aer installation, as it may
require re-adjustment
Leave T15 Post Torx
Security Screwdriver
with client
678
*Indicates correct gauges for anchor
system types listed; choice of anchor
system is at installer's discretion
Front of unit
BMP
will end up here
(between two holes)
Place Base Mounting Plate (BMP) halves
in position on the installation surface.
Position the BMP so that the Front of the
unit will be in the middle of 2 holes.
Mark anchor points on the surface
through BMP holes and drill out.
Fit o either 12mm threaded rods or
16mm dynabolts*
Remove PVC S-Trap inside to gain access
to the base of the unit.
Place unit over anchors, then place BMP
halves back inside unit over anchors and
secure in place.
PLease read Pre-installation at back page
ATTENTION: See next page for PRE-INSTALL GUIDE
au: 1300 213 7 74 nz: 0800 213 774 www.aquabubbler.com
5
Locate Internal Base Mounting Plates
Classic / Universal / Universal 2 aquaBUBBLER INSTALLATION
Mark
measurements
& dimensions
as indicated by
Schematic on
https://aquabubbler.com
1
Consult Schematic
Schematic
Download
Attach Side Pod
Connect pipe to tap fitting
Connect Black Director from Pod
to the Waste Pipe
Screw Side Pod to body with
a 5mm Allen Key (not supplied)
1
2
3
1
2
1
2
3
3
[ Universal only ]
Code: AB12 / ABUA13 / AB2UA14
