ARC-5020-3 Installation instructions for MacPro
5. Install the Areca ARC-5020-3 Card
The ARC-5020-3 has a cable and a card end.
Install the cable end into Drive Port 2 on
the motherboard. Then slide the card end into
the slot where the PCI bracket was removed.
Make sure the cable connector is securely into
the SATA port on the motherboard and the
card is fully seated into the slot.
6. Replace the PCI Bracket
Make sure the cable connector is securely
fit into the SATA port on the motherboard
and the card is fully seated into the slot.
Take the PCI bracket and re-insert to its
original location, then tighted both screws.
The PCI bracket will hold the ARC-5030-3
card in place.
4. Locate and Remove the PCI bracket
The PCI bracket will have two thumbscrews.
Loosen both thumbscrews until PCI bracket
can be easily removed. Remove the bracket
and the port access cover to allow room for
the ARC-5030-3 card to be installed.
NEXT
PAGE 2
Drive
Port 2
Drive
Port 4
Drive
Port 3
