Armstrong 11AV Manuale utente

Free Floating Lever Air/Gas Vents

Models 11AV, 22AV and 13AV

Installation and Operation Manual

46-C

Installation Procedures.............3

Troubleshooting......................4

Technical Data Charts...............5

Warning: This bullen should be used by experienced personnel as a guide to the installaon and

maintenance of the Armstrong Air/Gas Vents. Selecon or installaon of equipment should always be

accompanied by competent technical assistance. We encourage you to contact Armstrong or your local

representave if further informaon is required.

Overview

subject to change without notice.

Installation Procedures

Install air vents at all the high points on liquid service systems, hydronic systems, or any liquid storage or distribution

system. See Figures 1, 2 & 3 for typical installations.

Do not exceed the maximum allowable pressure noted on the label on the side of the air vent

body. Also, check to see if the air/gas vent has the proper maximum differential pressure for your

particular application.

When tightening a pipe into either the inlet or outlet ﬁttings of an 11AV, 22AV or 13AV use only the

hex-shaped ﬁttings as wrenching surfaces. Do not use other parts of the vent for wrenching as

unnecessary stress may be placed on the vent body.

Before installing the vent, ﬂush out the line to remove loose dirt. Use pipe dope or teﬂon tape

sparingly and on male threads only. Leave the end thread exposed to avoid introducing sealant into the

system.

The inlet and outlet piping should be the same size as the air vent connections. Do not reduce the size

of the inlet on light loads; however, smaller pipe or tubing may be used on the outlet. Keep the piping

as short as possible, with a minimum of valves and ﬁttings. If you are installing an air vent without

an equalizing connection, do not use elbows in the inlet line from the equipment to the vent.

Install gate valves or full ported ball valves (Do Not Use Globe Valves) so the air vent can be isolated

from the system to permit servicing. If the air vent is installed in a closed piping arrangement, install a

union on each side of the air vent.

Be certain the vent is installed properly. Note the direction of ﬂow arrow on the label and the red

label indicating UP for air and gas venting service.

Do Not use a pipeline strainer in the line leading to the vent.

Air vents should be installed so that they can be checked periodically. A drain line should be piped to

a ﬂoor drain or to a visible location where it can be regularly checked for leakage.

Caution: Do not install air vents with an open discharge where a malfunction could cause damage

i.e. above false ceilings.

11AV Air Vent

To Drain

Ball Valve

Return

High Point on Main

13AV Air Vent

22AV Air Vent

To Drain

Flow

Figure l. Installation of Model

11AV automatic air vent on high

point of main.

Figure 2. Installation of a Model 22AV

automatic air vent on loop in piping.

Figure 3. Continuous venting using

a Model 13AV with an equalizing

line where large amounts of air

must be vented. As air enters line

A, water leaves through line B.

Troubleshooting

Check operation. It is normal on hydronic systems to have no discharge from the vent, but this is not proof that

the vent is functioning properly. To check the air vent, disconnect the outlet piping and observe the discharge from

the unit. If the vent is working correctly, a little air should escape, followed by a small amount

of liquid.

When an 11AV, 22AV or 13AV is not operating properly, remove it from service and force water or air through the

discharge ﬁtting. Back-ﬂushing to remove scale and dirt often restores the air vent to its normal operating condition.

When an 11AV, 22AV or 13AV cannot be made to operate properly, replace it with a new one having the same oriﬁce

size.

For assistance with an unsual installation or service problems, contact your Armstrong Representative or Armstrong International’s Application

Engineering Department

On new installations, an air vent may fail to open if the maximum operating pressure on the label is less than the

actual pressure being encountered. If this is the case, replace the air/gas vent with one sized properly for your higher

maximum operating pressure. Consult your Armstrong Representative.

An unusual increase in system pressure may cause the air vent to lock shut. Either eliminate the cause of the

increased pressure or replace the air vent with one that can handle the peak pressures.

Free Floating Lever Air/Gas Vents - All Stainless Steel

Models 11AV, 22AV and 13AV

Maximum Operating Pressures of free floating lever vents with weighted floats for different orifice sizes, and the specific gravities on which they can be used.

11-AV Maximum Operating Pressures

Minimum Specific Gravity 0.75 0.50

Float wt., oz (g) 2.90 (82) Standard 2.08 (59) Special

Orifice Size (in) Maximum Operating Pressure

psi bar psi bar

1/8 178 12 118 8

#38 267 18 177 12

5/64 400 28 311 21

22-AV Maximum Operating Pressure

Specific Gravity* 1.00 0.95 0.90 0.85 0.80 0.75 0.70 0.65 0.60 0.55 0.50

Float wt., oz (g) 10.0 (282) 9.5 (268) 9.0 (254) 8.5 (240) .0 (226) 7.5 (212) 5.4 (152) 5.0 (141) 4.6 (130) 4.2 (119) 3.8 (109)

Orifice Size (in) Maximum Operating Pressure

psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar

5/16 35 2.4 33 2.3 31 2.2 30 2.0 28 1.9 26 1.8 19 1.3 18 1.2 16 1.1 15 1.0 14 0.9

1/4 57 3.9 54 3.7 51 3.5 49 3.4 46 3.2 43 3.0 31 2.1 29 2.0 27 1.8 24 1.7 22 1.5

3/16 126 8.7 120 8.2 113 7.8 107 7.4 101 7.0 95 6.5 68 4.7 64 4.4 59 4.1 54 3.7 49 3.4

5/32 217 14.9 206 14.2 195 13.5 185 12.7 174 12.0 163 11.2 118 8.1 110 7.6 101 7.0 93 6.4 85 5.8

1/8 371 25.6 352 24.3 334 23.0 316 21.8 297 20.5 279 19.2 202 13.9 187 12.9 173 12.0 159 11.0 145 10.0

7/64 474 32.7 451 31.1 427 29.5 404 27.9 380 26.2 357 24.6 258 17.8 240 16.5 222 15.3 204 14.0 186 12.8

#38 590 40.7 561 38.7 532 36.7 503 34.7 473 32.7 444 30.6 321 22.1 298 20.6 276 19.0 253 17.5 231 15.9

5/64 600 41.4 600 41.4 600 41.4 600 41.4 600 41.4 600 41.4 473 32.6 440 30.3 407 28.1 374 25.8 341 23.5

13-AV Maximum Operating Pressures

Specific Gravity* 1.00 0.95 0.90 0.85 0.80 0.75 0.70 0.65 0.60

Float wt., oz (g) 14.9 (423) 14.2 (402) 13.4 (381) 12.7 (360) 12.0 (339) 11.2 (318) 10.5 (296) 9.7 (275) 9.0 (254)

Orifice Size (in) Maximum Operating Pressure

psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar psi bar

1/2 21 1.5 20 1.4 19 1.3 18 1.3 17 1.2 16 1.1 15 1.0 14 1.0 13 0.9

3/8 45 3.1 43 3.0 41 2.8 38 2.7 36 2.5 34 2.3 32 2.2 30 2.0 27 1.9

5/16 72 5.0 69 4.7 65 4.5 61 4.2 58 4.0 54 3.8 51 3.5 47 3.3 44 3.0

9/32 96 6.6 91 6.3 87 6.0 82 5.6 77 5.3 72 5.0 68 4.7 63 4.3 58 4.0

1/4 144 9.9 137 9.4 130 8.9 123 8.5 116 8.0 109 7.5 102 7.0 94 6.5 87 6.0

7/32 206 14 196 13 186 13 176 12 165 11 155 10.7 145 10.0 135 9.3 125 8.6

3/16 309 21 294 20 279 19 264 18 249 17 234 16 218 15 203 14 188 13

5/32 484 33 460 32 437 30 413 28 389 27 365 25 342 24 318 22 294 20

1/8 570 39 570 39 570 39 570 39 570 39 570 39 570 39 570 39 570 39

7/64 570 39 570 39 570 39 570 39 570 39 570 39 570 39 570 39 570 39

*If specific gravity falls between those shown, use next lowest: e.g., if actual gravity is 0.73, use 0.70 specific gravity data.

Armstrong International

816 Maple Street, Three Rivers, MI 49093 – USA Phone: (269) 273-1415 Fax: (269) 278-6555

armstronginternational.com

46-C

Printed in U.S.A. - 11/11

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Armstrong Pompa dell'acqua

Armstrong

Armstrong 4280 Series Manuale utente

Armstrong

Armstrong HEP OPTIMO Manuale utente

Armstrong

Armstrong 4600 HSC series Manuale utente

Armstrong

Armstrong 4280 Series Manuale utente

Armstrong

Armstrong 4300 Series Manuale utente

Armstrong

Armstrong Design Envelope 4300 Manuale utente

Armstrong

Armstrong AGE4D Manuale utente

Armstrong

Armstrong Design Envelope 4380 Manuale utente

Armstrong

Armstrong Design Envelope 4300 Manuale utente

Armstrong

Armstrong HEP Optimo S Manuale utente

Armstrong

Armstrong Design Envelope 4300 Manuale utente

Armstrong

Armstrong 4302 IVS Series Manuale utente

Armstrong

Armstrong 4280 Series Manuale utente

Armstrong

Armstrong Design Envelope 4300 Manuale utente

Armstrong

Armstrong 79730-90 Manuale utente

Armstrong

Armstrong Double Duty 6 Manuale di istruzioni

Armstrong

Armstrong Design Envelope 4300 Manuale utente

Armstrong

Armstrong Design Envelope 4302 Manuale

Armstrong

Armstrong LIFT NT25 Manuale utente

Armstrong

Armstrong Design Envelope 4322 Manuale utente

Armstrong

Armstrong 4302 Series Manuale utente

Armstrong

Armstrong ASTRO 220SSU Manuale utente

Armstrong

Armstrong IVS series Manuale utente

Armstrong

Armstrong 4039 Series Manuale utente

Manuali Pompa dell'acqua popolari di altre marche

Neptun

Neptun NPHW 5500 Manuale utente

Sensidyne

Sensidyne Gilian BDX-II Istruzioni per l'installazione e il funzionamento

Draper

Draper 47808 Manuale utente

Trolla

Trolla 12820 Manuale utente

Sunfab

Sunfab SVH Series Manuale utente

WilTec

WilTec 50740 Manuale utente

Fieldmann

Fieldmann FVC 5015 EK Manuale utente

Everbilt

Everbilt EFSUB5-122HD Manuale utente

Graco

Graco Husky 3300e Manuale utente

esotec

esotec 101018 Manuale utente

moyno

moyno 2000 CC Manuale utente

Becker

Becker BASIC VASF 2.80/1-0.AC230 Manuale utente

Sykes AmeriPumps

Sykes AmeriPumps GP100M Guida alla risoluzione dei problemi

DUROMAX

DUROMAX XP WX Series Manuale utente

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Manuale utente

Franklin Electric

Franklin Electric IPS Manuale utente

Xylem

Xylem e-1532 Series Manuale utente

Milton Roy

Milton Roy PRIMEROYAL Manuale utente