INSTALLATION AND OPERATION MANUAL
CR3 CR5, and CR7 Charging Racks Introduction
• Suomi: Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.
• Norge: Apparatet må tillkoples jordet stikkontakt.
• Sverige: Apparaten skall anslutas till jordat uttag.
• Danmark: Apparatets stikprop skal tilsluttes en stikkontakt med jord som giver forbindelse til stikprop-
pens jord.
1 4 Regulatory Compliance Statements (EU and EFTA only)
This equipment is intended to be used in the whole EU & EFTA.
This equipment is in compliance with the essential requirements and other relevant provisions of EMC
Directive 2014/30/EU, LVD Directive 2014/35/EU and of Directive 2015/863 (RoHS3) amending 2011/65/EU.
The complete Declaration of Conformity is found at https://www.ascom-ws.com/doc/.
The product is marked with
1 5 Regulatory Compliance Statements (UK only)
This equipment is in compliance with the essential requirements and other relevant provisions of
Electromagnetic Compatibility Regulations 2016, Electrical Equipment (Safety) Regulations 2016, and the
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations
2012.
The complete Declaration of Conformity is found at https://www.ascom-ws.com/doc/.
The product is marked with
1 6 Regulatory Compliance Statements (USA and Canada only)
FCC Compliance Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
Modifications
Changes or modifications to the equipment not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
TD 92480EN / 17 August 2021 / Ver. M 4
