Ashford BLENDING BOARD Manuale utente
Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture we will replace the item. To validate our guarantee
please visit our website or write to us.
Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton 7700 New Zealand
Telephone 64 3 308 9087 Facsimile 64 3 308 8664
INSTRUCTIONS
BLENDING BOARD
BB230715V2
Dowels
Blending Brush
Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton 7700 New Zealand
Telephone 64 3 308 9087 Facsimile 64 3 308 8664
1. Attach the keel to the blending board with the keel bolt.
Use position 1 if you are working on a table or 2 or 3 if working
on your lap.
2. To use the blending board on your lap, loosen the keel
bolt slightly, position the keel between your knees with the
handle away and rotate the blending board to a comfortable
working position.
3. Starting at the handle end, apply thin layers of fibre onto
the teeth mixing colours and fibres as you go.
4. Use the blending brush to pack the fibres down into the
teeth. Apply more layers of fibre and brush into the teeth until
the board is full.
5. To remove the fibre and make a rolag, pull some fibres out
from the bottom and wrap them around one dowel. Then trap
these fibres by holding the second dowel on top of the first.
6. Pull the dowels towards you stretching and carding the
fibres. Then wrap these fibres around both dowels as you draft.
You can easily make 4 or more rolags from each full board.
7. Slide one dowel out of the rolag
and then the other. Your fibre is now
ready to spin into beautiful yarn.
Keel Bolt
Keel
Altri manuali Ashford Accessori per macchine da cucire
