★ Power on: Please confirm the power supply is correct for the controller before connection. After power on, the
controller will start reseting. You may see the LED indicators flashing.
★ Fixture selection: After power on, the fixture selection buttons are inactivated and the sliders are not ready to
work.. Press the fixture selection buttons to select fixtures. When the LED indicator of Multi is on, two or more
fixtures can be selected; otherwise, only one fixture can be selected at a time.
★ Manual control: After activating the fixtures, you can control the fixtures by pushing the sliders. If the fixtures
do not response to the sliders, push the slider to the bottom and try again. The brightness of the sliders’ LED
indicators indicates the output value. It the indicator is flashing, it means the output value on the slider is 0. The
output by manual control is prior to the output by a running scene /chase /chase group. Press and hold Release,
then push a slider, the output of the channel by manual control will released.
Note:
◇Press and hold Release, then push a slider to release the channel and the LED indicator will be off.
But, if there is a scene/ chase/ chase group running on that channel, the brightness of the LED
indicator will change according to the output value.
◇Press Clear to clear all manual output. All the LED indicators of the sliders will be off.
◇Manual output is prior to the output of a running scene /chase /chase group.
★ Clear
When one of the LED indicators of SC1, SC2, SC3, Chase1, Chase2 and Group is on, press Clear
once, it will clear all manual output.
When one of the LED indicators of SC1, SC2 and SC3 is on, press Clear and hold for about 1
second, it will clear all manual output and close all the running scenes.
When one of the LED indicators of Chase1 and Chase2 is on, press Clear and hold for about 1
second, it will clear all manual output and close all the running chases.
When the LED indicators of Group is on, press Clear and hold for about 1 second, it will clear all
manual output and close all the running chase groups.
V. Create a Scene
Note:
The LED indicators of the sliders with manual output will be on or flashing (output value = 0). The values
will all be saved into the scene. However, if the LED indicators are off, they will not be saved. If you
Step Description
1 Select the desired fixtures.
2 Push the sliders to adjust the lighting effects.
3 Press Program to enter programming mode.
4 Select one of SC1, SC2 and SC3 to store the scene.
5 Select one number from 1--18 to store the scene.
6 After saving the scene into the number button, it will automatically exit the programming
mode.
