Analog Output Selection
◆The default analog output is 0-10V. If you want to change to 4-20mA output, please follow the below.
◆ Open the cover, you can see five black blocks of J1 & S1~S4. The J1=OFF corresponding
to 0-10V and the J1=ON corresponding to 4-20mA. At the same time, connect ‘V’ side of S1~S4
corresponding to 0-10V and connect ‘A’ side of S1~S4 corresponding to 4-20mA. As shown figure 4.
Modbus Register
Mode: RTU (MSB First)
Baud Rate: 1-4800 2-9600 3-14400 4-19200 5-38400 bps default: 2-9600bps
Start Bits: 1
Data Bits: 8
Stop Bits: 1 / 2 default : 2
Parity: None / Odd / Even default: None
Modbus Address: 1~247 default: 1
Register Map
Support Function: 3 4 6 16