- 6 -
SYSTEM COMPONENTS
Thi TRIO MASTER stereo system is composed by three elements:
Active Subwoofer STAGE PRO W15
1 Active Subwoofer STAGE PRO W15
2 Passive Satellites STAGE PRO 10
The active subwoofer STAGE PRO W15 is equipped with a
The cabinet integrates all necessary electronics for amplification and system
3 amplifiersi in AB Class for a total power of 720 W RMS (1440 W Max)
15" (380 mm) woofer with 75 mm VC.
1 x 380 W RMS (760 W Max) for the Subwoofer itself
2 x 170 W RMS (340 W Max) for the two passive satellites (@ 4 Ohm load)
processing:
- 3 -
The Subwoofer signal is LowPass filtered, adjustable from 46 to 240 Hz 12 dB/oct.
Cabinet of high density MDF, anti-scratch embossed painting
Connections and Control Panels
Sizes & weight: 58 x 48 x 55 cm; 43.5 kg.
Practical transport handles hollowed into the wood
Integral rigid metal grill
Housing hole for ø 35 mm stand tubes
On/Off power switch - In positioe 0 the system is Off
15
16 Voltage Selector
17 Power Net Socket
Left Channel Lin In
Combo Socket XLR 3-F / Jack 6,3 mm Balanced
10
Right Channel Line In
10
11
Speakon Socket Right Satellite
12
Speakon Socket Left Satellite
13
Amplifier cooling fan; keep it clean for a correct ventilation.
14
Combo Socket XLR 3-F / Jack 6,3 mm Balanced
OUT+:1+/OUT- :1-
GND=1=SLEEVE HOT=2=TIP COLD=3=RING
USEONLYWITH 250V FUSE
220
OUTPUT
LEFT RIGHT
180W@4Ù
SPEAKER OUTPUT:
LINE IN
LEFT RIGHT
LR
LOW PASS
-15 +15 0 10
HI PASS GAIN
PEAK
-15 +15
0 10
GAIN HI PASS
PEAK
LEFT speaker RIGHT speaker
0 10
GAIN
PEAK
50 260
80
120
60
Hz
PHASE
SHIFT
0-180°
Subwoofer
50 260
80
120
60
Hz 50 260
80
120
60
Hz
HIGH
PEAK
HIGH
15 17
16
14
3
1
2
4
7658 5 678
11
13
POWER
9
12
The Satellites signals are HighPass filtered, adjustable from 38 to 250 Hz 12 dB/oct.
1Subwoofer Clip Indicator
2Subwoofer LOW PASS control adjustable from 46 to 240 Hz
3Subwoofer Volume control
4Phase Switch 0-180°
5Satellites Clip Indicator (Separated Left and Right)
6Satellites Volume control separated on channel LEFT and RIGHT.
it controls only the signal going respectively to left and right satellite.
High tones equalization separated for left and right channel -15 / +15 dB
7
8Satellites HI PASS control separated LEFT and RIGHT from 38 to 250 Hz
9ON LED indicator (Red)
ATTENTION: the HI PASS frequency should not be set under 120 Hz
Satellites Volume setting
6
6
Switch power on and begin to turn clockwise the satellite GAIN knobs until the correspondent PEAK led begins
This is the optimal level being connected to a mixer sending to MAIN a signal with level peaks within 0 and +3dB.
Now listen to the satellites with this output level; if you detect distorsion or saturation of the signal (i.e of microphone) check
the possibility of reducing the level of the signal concerned at his source, otherwise try to slightly lower the mixer’s main
otput. Should this not be enough, reduce the satellites volume until you have an optimal sound.
Sub Volume setting
3
Volume setting of the system is made by means of the three LEVEL
knobs on top of the subwoofer:
- Left satellite is GAIN LEFT
- Right satellite is GAIN RIGHT
- Subwoofer is GAIN SUBWOOFER
Before switching power on and proceed to system setting, make sure that
all three knobs are completely turned counterclockwise, at level 0, and that the mixer output is set so that the peaks level
Set first the satellites volume alone and then the subwoofer volume alone.
After having memorized the knobs setting LEFT e RIGHT, take them back to 0 and begin now to turn clockwise the
SUBWOOFER GAIN knob until the correspondent PEAK led begins to flash shortly for less than 1 second.
This is the optimal level being connected to a mixer sending to MAIN a signal with level peaks within 0 and +3dB.
Now listen to the Sub with this output level; if you detect distorsion of basses, turn slightly the knob back counterclokwise.
Final system setting
Bring the three knobs at the optimal level you have checked and listen to the complete system, again at the mixer
main level peaks between 0 and +3 dB.
If you detect to much basses compared with satellites output, turn slightly back the SUB LEVEL knob.
If you detect instead not enough basses, turn slightly back the setellites LEVEL LEFT and RIGHT knobs.
LR
LOW PASS
-15 +15 0 10
HI PASS GAIN
PEAK
-15 +15
0 10
GAIN HI PASS
PEAK
LEFT speaker RIGHT speaker
0 10
GAIN
PEAK
50 260
80
120
60
Hz
PHASE
SHIFT
0-180°
Subwoofer
50 260
80
120
60
Hz 50 260
80
120
60
Hz
HIGH
PEAK
HIGH
3
6 6
POWER
stays about within 0 e +3 dB.
6
to flash shortly for less than 1 second.
3
Sensitivity Magnitude
dB SPL/watt (4 ohm load)
-
log Frequency - Hz
MLSSA: Frequency Domain
M
L
S
S
A
10000.01000.0100.020.0
auto
45.0
50.0
55.0
60.0
65.0
70.0
75.0
80.0
85.0
90.0
95.0
AUDIODESIGN PRO: TRIO MASTER
RESPONSE DIAGRAM TRIO MASTER
@ 1W/1m
Portable Full Range Sound System TRIO MASTER Portable Full Range Sound System TRIO MASTER
Memorize the knobs setting.
As a general rule , the output level of the mixers should be set so that the sound peaks remain between 0 to +3 dB
about. When the system TRIO MASTER gets in the two Line In (10 and 11) a signal with that amplitude and it is
set as explained above, it grants the maximum performance in terms of maximum undistorted amplification (at clip
limit) and in this conditions you get the maximum possible sound pressure (SPL).
ST
MONO
18
18 ST/MONO Switch (Stereo / Mono): se si seleziona STEREO,
correspondent Right and Left input signals.
When the system sends to both Right and Left channels onlyMONO is selected,
the LEFT input signal, so one complete system per channel can be used..
When STEREO is selected, the system sends to the Right and Left channels the
