IMPORTANT SAFETY INSTRUCTIONS
CAUTION: to reduce the risk of electric shock, do not remove cover (or back). No user-serviceable
parts inside. Refer servicing to qualied service personnel.
The lightning ash with arrowhead sym-
bol, within an equilateral triangle, is in-
tended to alert the user to the presence
of an uninsulated “dangerous voltage”
within the product’s enclosure that may be of suf-
cient magnitude to constitute a risk of electric
shock to persons.
The exclamation mark within an equilat-
eral triangle is intended to alert the user
to the presence of important operating
and maintenance (servicing) instruc-
tions in the literature accompanying the
equipment.
INSTRUCTIONS
Before installing or operating the equipment, read
all safety instructions, warnings and operating in-
structions.
Heed all warnings. Follow all instructions. Keep all
safety, installation and operating instructions for
future reference.
INSTALLING AND OPERATION LOCATION
Do not use this apparatus near water. Do not ex-
pose this apparatus to drips or splashes. Do not
place any objects lled with liquids, such as vases,
on the apparatus.
Do not install near any heat sources such as radi-
ators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat. No naked
ames, such as lighted candles, should be placed
on the apparatus.
Do not install the apparatus in a conned space
such as a book case or similar unit. Do not block
any ventilation openings.
Ensure that foreign objects and liquids cannot get
into the equipment.
Install in accordance with the manufacturer’s in-
structions. Only use attachments/accessories spec-
ied by the manufacturer.
Use only with the cart, stand, tripod, bracket or ta-
ble specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid in-
jury from tip-over .
The apparatus should be located close
enough to the AC outlet so that you can
easily grasp the power cord plug at any
time.
The mains plug, the appliance coupler or the mains
switch is used as the disconnect device. Either de-
vice shall remain readily operable when the appa-
ratus is installed or used.
POWER SOURCE AND GROUNDING
This product should be operated only from the
power source indicated on the apparatus or in
the operating instructions. If you are not sure of
the type of power supply to the premises where
the equipment is to be used, consult your product
dealer or local power company.
Do not defeat the safety purpose of the polarised
or grounding-type plug. A polarised plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong is provid-
ed for your safety. If the provided plug does not t
into your outlet, consult an electrician for replace-
ment of the obsolete outlet.
Connect Class I construction apparatus to an AC
outlet with a protective grounding connection.
Do not overload wall outlets, extension cords or in-
tegral convenience receptacles, as this can result in
a risk of re or electric shock.
Protect the power cord from being walked on or
pinched, particularly at plugs, convenience recepta-
cles and the point where they exit from the appara-
tus. Unplug this apparatus during lightning storms
or when unused for long periods of time.
POWER SUPPLY AND POWER CORD REQUIRE-
MENTS:
Power supply class I grounding requirements:
For protection from fault currents, the equipment
shall be connected to a grounding terminal. Plug
the system power cord into an AC outlet that pro-
vides a ground connection.
Substitute cords may not provide adequate fault
protection. Only use the power cord supplied with
this product or an authorized/equivalent replace-
ment.
Safety notices:
Denmark:
Apparatets stikprop skal tilsluttes en stikkontakt
med jord, som giver forbindelse til stikproppens
jord.
Finland:
Laite on liitettävä suojakoskettimilla varustettuun
pistorasiaan.
Norway:
Apparatet må tilkoples jordet stikkontakt.
Sweden:
Apparaten skall anslutas till jordat uttag.
