SUNILDA ultra highend phono tube amplifier____________________________
Factory assembly & getting started
Once the a plifier has arrived at its desired destination, ake sure the a plifier has a ple ti e to
adjust to the cli ate at its new location. It is likely that the changes in te perature and hu idity
between the last location and the new one, has caused condensation to build up so ewhere in the
a plifier.
This can da age the device. Please allow the a plifier at least two hours to accli atise.
The a plifier co es fully asse bled, ready to go. The powercord should not be used as yet, please
connect all other input and output connectors first (cinchcables, speakercables, etc).
The device MUST be switched off while connecting it to other co ponents, it ight be da aged if this
is done with the a plifier under power. The person operating the a plifier ight be hurt as well in this
case, since powerspikes, operating currents and voltage charges ay occur!
Check whether the ON/OFF switch is in the OFF position. If so, you can now plug in the
powercord.
Use high quality cables only! Usage of DIY cables, low spec cables or cables intended
for other use voids all warranty and cancels any product liability. Make sure all plugs are connected
tightly to the a plifier. When in doubt, replace the cable.
Always use the device in a
’
co plete configuration
’
, da ages ay occur when devices are not
connected to the a plifier when it is being run.
Never lift the device by its glass cover, not even when there are gripps attached to the cover. The
gripps and the cover are there for orna ental purposes only. They ake the a plifier look nice.
The a plifier should be positioned at a level surface, in ti e the construction of the glass housing ay
fail as a result of tensile forces.
Please disconnect and ove the a plifier when you replace tubes. Replace the at a place where
you can work easily. You ight da age the
’
otherboard
’
if you replace the tube in an awkward
position. After that please check all connectors. If all connectors are unda aged, ake sure the
switch is in the OFF position, reconnect the powercord and swith the a plifier on. You can ake sure
the a plifier is properly connected by checking the tubes. Only the inside of the tube should glow. If
the steel coverjacket glows as well, the device is faulty and ust be serviced i ediately.
As a rule of thu b the device should work now. Don
’
t push the volu e up to its axi u just yet,
allow the device to burn in s oothly and avoid powerspikes.
The SUNILDA Pre-A plifier needs at least a 1.6 A pere slow blow circuit breaker in the fuse holder
for 230 VAC ain voltage and 3,15 a pere slow blow by 115 VAC. Make sure your wall socket is equiped
in such a fashion.
