Page 2of 18
terminals connecting the equipment must be corresponding to each other. When connecting to the device signals,
it’s suggested to terminate the DMX signal so as to avoid decaying the signal strength caused by the signal reflection.
DMX signal terminator is a resistance of 120 ohms/1w connecting the number two and three pins on the XLR plug,
the resistance is connected to the output socket of the last device.
The definition of Three Pin XLR Plug: 1 Signal Ground line; 2 Signal-; 3 Signal+
Note:
1. After the equipment starts up, it first needs to warm up. When the READY sign lights up, it indicates that the equipment is ready. You can operate
the effect machine.
2. No foreign material (flammable) is allowed to cover the surface of the equipment, so as not to affect its cooling or impede the operation of the
fountain. Do not place anything on sides or top that would impede cooling.
3. If find fountain becomes small, please add Sparkular Granules.
5) Operation Panel:
a) LCD information display area, showing action menu and operating status of the equipment.
b) LED Displaying Area：
READY: Flashing shows that the system is preparing, Solid Light shows that the system can operate.
DMX: Flashing shows that the DMX signal is connected, no display shows that there is none connected.
FAULT: Sign will light up when any error is detected.
HEAT：Sign will light up when the system is heating.
c) Control Button Area：
MENU: entering into the menu select
DOWN: parameter reduction
UP: parameter increase
ENTER: confirm and save parameters
d) Interface and Plugging Area：
POWER IN: BT01 is 220Vac and BT02 is 110Vac
POWER OUT: BT01 is 220Vac and BT02 is 110Vac
DMX IN: DMX Communication Signal Input
DMX OUT: DMX Communication Signal Switching Output
