Audiosystem C Series Manuale utente

designed and engineered by audio system Germany

the sound

since 1988

High-Performance

Car-amplifier

owner‘s manual

C0-600.5

features

Congratulation on your purchase of your new c-Series amplifier.

IMPORTANT: Before installation your power amplifier, we recommend to read the owner´s manual carefully and to

follow the instructions regarding connection and fitting exactly.

ATTENTION: Pay attention to advices and instructions of the car manufacturer.

IMPORTANT: Your proof of purchase is evidence of warranty claim for repair or replacement. Keep your proof of

purchase, manual and original packaging.

ATTENTION: Use of sound components can impair your ability to hear necessary traffic sounds and may constitute a

hazard while driving your automobile.

Audio System Germany accepts no liability for hearing loss, bodily injury or property damage as

a result of use or misuse of our products. We recommend installing the equipment by an authorized service center or

dealer. A professional fitting and connection is the requirement for further warranty and perfect sound.

CO-600.5

- 5-Channel High Power Class-AB amplifier with SMD technology

- MOS-FET PWM Power Supply

- 6-Kanal-Eingang

- Input-Mode 2 or 4 or 5 channel

- Stabil into 2 ohm stereo per channel and 4 ohm in bridged mode (channel 1+2+3+4)

- Stabil from 4 ohm to 2 ohm mono (channel 5)

- Variable switchable Low / High Pass Filter from 50 to 4000 Hz (channel 1+2)

- Variable switchable Low / High / Band Pass Filter from 30 to 1500 Hz (channel 3+4)

- Variable switchable Low Pass Filter from 30 bis 200 Hz (Kanal 5)

- 3-Way Full Active Mode possible

- Input Sensitivity: variable 200 mV maximum to 8 v minimum

- Multi-Way Protection Circuitry: overheating, overcurrent, short circuitry and speaker

DC protection

- Operating Voltage: DC 10 ~ 16 V power input

- Wired Remote Control RTC included

- High-Power-Input (normally originial radio) with automatically „Turn-On“

- Adaptercable HLAC and rca hi (optional)

READY

power connection

BATTERY

GROUND

3. +12 V Power connection:

Connect the +12 V contact of the amplifier with the supply cable via a fuse directly to the vehicle battery. Keep in

mind, that the length of the cable from fuseholder to vehicle battery has to be a maximum of 30 cm. Requirement for

a perfect function of the amplifier is a qualitative high end fuse holder as well as a suitable cable cross section (AWG

sice 6 - 4). This fuse protects the amplifier and the vehicle against the possibility of a short circuit in the power cable.

4. Remote connection

Connect the REM-terminal of the amplifier to the remote-output (automatic 12 V antenna-output) of the head unit.

Therefore use a 0,5 - 1,5 mm (AWG sice 20 - 16) power cable.

FUSE

GND REM +12V

to REMOTE Turn-on

from HEAD UNIT

HEAD UNIT

1. Battery disconnection

First disconnect the power supply of the vehicle.

This works out the best by removing the ground

cable of the battery.

2. Ground connection

Connect the GND (ground) connection of the

amplifier with the car chassis. Keep this cable

as short as possible (not longer than 50 cm) and

use a suitable cross section (AWG sice 6 - 4).

Make sure, that the connection with the vehicle

chassis is free of paint, dirt and dust.

Fuse

Max.30 cm

a) Take care of a professional attachement. Pay attention, that no electrical cable, gas tank, hydraulic

breakes or other components get damaged.

b) There has to be enough cooling and air circulation. Avoid the installation in small closed boxes or close

to heatening parts.

c) Protect the amplifier from fluids, wetness, heat and foreign material as well as from other influences.

d) The amplifier is only to be built into vehicles with a 12 V DC power supply.

e) Never install the power supply cable with other original wires of the vehicle (gas cables), fan motors,

brand control moduls etc.

f) Install the signal cable (cinch cable) as well as the speaker cable far away of the power cables to avoid

troubles with the music signal.

g) The cables of your amplifier have to be installed, so that there is no danger of binding, squeezing or

breaking.

Please follow the instructions during the installation of your amplifier:

ATTENTION

CO-600.5

RCA connection

The c Series amplifier offers RCA-Inputs, which are connected through cinch cables with the preamplifier-

outputs of the head unit. If the head unit (OEM-RADIO) has no RCA-Output, than it is possible to connect the speaker

output direct to RCA/Cinch-Input of the amplifier.

The Input Mode has to be switched on “HI“. Important: the Gain-Controller has to be adjusted to minimum,

then carfully turn up the volume. If signal is presented, the amplifier automatically turns on. Adaptercable HLAC

and RCA HI can be purchased at your specialized dealer.

With the aid of the variable high- and lowpassfilter, phase shift-controller, the gain-controller and subsonicfilter you

are able to adjust the amplifier on to your prefered taste of hearing, the circumstances of the vehicle and to the

speakers.

Optional a wire remote controller RTC can be installed to adjust the output level.

In this regard, AUDIO SYSTEM germany recommends to adjust your amplifier through a

specialized service center, dealer or a specialist.

co-600.5

HEAD UNIT

Remote Control

RTC (optional)

for channel 3 + 4

INPUT MODE

2CH

LPF

4CH

FULL

5CH

HPF

MIN

MIN MIN

30Hz 30Hz

50Hz

X-OVER

SUB IN

MAX

MAX MAX

400Hz 200Hz

4KHz

LOW

CH 1 /2

RE M OTE

LP F

CH 3 /4

SUB 1 SUB 2

speaker connection

CO-600.5

5-Channel Stereo Mode channel 1 bis 4 + mono Channel 5

5-Channel Mono Mode channel 1 bis 4 + mono Channel 5

speaker

impedance

2 ~ 8 Ohm

speaker

impedance

4 ~ 8 Ohm

speaker

impedance

2 ~ 8 Ohm

speaker

impedance

4 ~ 8 Ohm

speaker

impedance

2 ~ 8 Ohm

SUBWOOFER

CH 1 CH 2

CH 1+2

CH 3 CH 4

SP EAK ER

CH 3+4

CH 1

speaker

impedance

2 ~ 8 Ohm

Trouble Shooting

This power amplifier is featured with an efficient protection system to prevent any damages like over-heating,

overvoltage, short-circuit and DC at the loudspeaker output.

Occuring an error the protection-LED will light in red. In order to check the problem, first turn down all levels of

the head unit, afterwards turn it off.

AMPLIFIER IS NOT

POWERED UP, NO LED IS

LIGHTENING

- ground connection professional connected?

- +12V powercable professional connected?

- remote cable professional connected?

- fuses inserted and alright?

- analyze voltage on the amplifier.

- cinch cable alrith and professional connected

- loudspeaker professional connected?

- head unit alright?

- amplifier too hot?

- short-circuit at the loudspeaker output?

- short-circuit caused by loudspeaker cable with vehicle chassi (ground)?

- input voltage too high (e.g.faulty generator)?

PROTECTION LED

ILLUMINATES GREEN

WHILE AMPLIFIER IS

SOUNDLESS

PROTECTION LED

ILLUMINATES RED

WHEN AMPLIFIER IS

POWERED UP

ERROR IN AMPLIFIER FUSE - ground professional connected?

- loudspeaker impedance alright?

! CAUTION !

Make sure when changing fuses to use the same value.

SOUND TOO LOW OR

LOW-DISTORTED SOUND

- input level control “GAIN” is set to match the head unit?

- output level control of the head unit alright?

- loudspeaker error?

- loudspeaker cable checked?

- crossover frequencies has been properly set?

(Check head unit, amplilfier, DSP, soundprozessor, equalizer,

frequency bandpassfilter...)

- ground connection professional connected?

- short-circuit caused by loudspeaker cable with vehicle chassi (ground)?

- cinchcable (RCA) and/or loudspeaker cabel installed too

close to the power connection cable?

- cinch ground (RCA) of the head unit alright?

HIGH HISS-ENGINE NOISE

IN SPEAKERS

Please contact your specialized dealer if the amplifier is still not working after it has been

checked with the error list!

For warranty adjustement / repairs the original invoice has to be attached!

Opening the power amplifier is leading to a lost of warranty in either case!

AT TEN T ION

OVERHEATING

(PROTECTION LED

ILLUMINATES RED WHEN

AMPLIFIER IS POWERED UP)

- impedance alright?

- loudspeaker error?

- adequate airflow of the amplifier?

! CAUTION !

After cooling down, the amplifier turns on automatically.

specifications

designed and engineered by audio system Germany

co-600.5

Power Supply Voltage

Rated Power Output at 14,4 V

-RMS power @ 4 ohm stereo (channel 1 to 4)

-RMS power @ 2 ohm stereo (channel 1 to 4)

-RMS power @ 4 ohm mono (channel 1 to 4)

-RMS power @ 4 ohm mono (channel 5)

-RMS power @ 2 ohm mono (channel 5)

Signal to Noise Ratio

High / Low Pass Crossover (channel 1 + 2)

High / Low Pass Crossover (channel 3 + 4)

or Band Pass Crossover (channel 3 + 4)

Low Pass Crossover

Frequency Response

THD@RMS Watts

Channel Separation

Fuse Rating

Input Sensitivity

Dimensions

10 - 16 V

4x 60 W

4x 85 W

2x 170 W

1x 250 W

1x 350 W

>96 dB

50 ~ 4000 Hz

30 ~ 400 Hz

30 ~ 400 Hz / fest 1500 Hz

30 ~ 200 Hz

10 ~ 45 KHz (+/-1 dB)

< 0,048%

75 dB

2x 25 A

200 mV ~ 8 V (+/- 5%)

420(W) x 47(H) x 171(L) mm

designed and engineered by audio system Germany

READY

the sound

since 1988

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Audiosystem Impianto stereo per auto

Audiosystem

Audiosystem SUBFRAME R08 FLAT EVO Manuale utente

Audiosystem

Audiosystem MFIT EVO2 Manuale utente

Audiosystem

Audiosystem EVO 2 M Series Manuale utente

Audiosystem

Audiosystem HX SQ EVO 2 Series Manuale utente

Audiosystem

Audiosystem CO 06 DC Manuale utente

Audiosystem

Audiosystem X165 A6 Manuale utente

Audiosystem

Audiosystem CO 06 DC EVO Manuale utente

Audiosystem

Audiosystem R100 Manuale utente

Audiosystem

Audiosystem MFIT EVO Manuale utente

Audiosystem

Audiosystem HS 30 PA EVO Manuale utente

Audiosystem

Audiosystem XCFIT EVO Manuale utente

Audiosystem

Audiosystem HX DUST Series Manuale utente

Audiosystem

Audiosystem MFIT EVO2 Manuale utente

Audiosystem

Audiosystem CO 08 QC EVO Manuale utente

Audiosystem

Audiosystem EVO 2 M100 Manuale utente

Audiosystem

Audiosystem MFIT MERCEDES SPRINTER W907 EVO 2 Manuale utente

Audiosystem

Audiosystem AS 165 EM EVO Manuale utente

Audiosystem

Audiosystem MFIT VW GOLF 5 EVO Manuale utente

Audiosystem

Audiosystem FWK M Manuale utente

Audiosystem

Audiosystem COFIT EVO Manuale utente

Audiosystem

Audiosystem DSP-BOX Manuale utente

Audiosystem

Audiosystem M-165 AUDI EVO Manuale utente

Audiosystem

Audiosystem X-Series EVO-2 Manuale utente

Audiosystem

Audiosystem MFIT VW T6.1 EVO 2 Manuale utente

Manuali Impianto stereo per auto popolari di altre marche

JL Audio

JL Audio Stealthbox SB-CAN-G2MVX3D/10TW3 Manuale utente

Clarion

Clarion PU-9836A Manuale utente

Sony

Sony MEX-BT5750U Manuale utente

Mitsubishi Electric

Mitsubishi Electric AR0M Manuale utente

Sony

Sony RM-X7BT Manuale utente

Insignia

Insignia NS-HD5113 Manuale utente

Clarion

Clarion BTD3341 Manuale utente

USA SPECS

USA SPECS PA11-VW6 Manuale utente

Sony

Sony MEX-N4380BT Manuale utente

Kenwood

Kenwood KCD-BT6544U/UY Manuale utente

JVC

JVC KD-DB912BT Manuale utente

Philips

Philips CSQ405/98 Manuale utente

Alpine

Alpine TDM-7544 Manuale utente

Autotek

Autotek TransAm TA 1400 Manuale utente

Clarion

Clarion PN-3124N-A Manuale utente

Denso TEN

Denso TEN FT0108A Manuale utente

Pyle

Pyle PLD57MU Manuale utente

Harman

Harman Chrysler Radio Navigation System RB4 Manuale utente