Audiovox AS 9076N Manuale utente

128-8496

1 of 4

Page1

Model AS 9076N

Owner’sManual

Remote Start

Upgrade Module

FEATURES :

♦Remote Start Safety Control Switch

♦ Selectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)

♦On-Board Start Relay

♦ On-Board Accessory Relay

♦On-Board Ignition 1 Relay

♦On-Board Ignition 2 Relay

♦Ignition 2 Relay Selectable On or Off During Cranking

♦On-Board Parking Light Relay

♦ Ignition 3 / Shock By-Pass / GM VAT Output (relay required)

♦Tach Signal Learning Circuitry

♦Two ( + ) and Two ( - ) Safety Shutdown Circuits

♦Alarm By-Pass Outputs

♦ Selectable Steady or Flashing Parking Lights for Run Indication

♦ Selectable 10 or 15 Minute Run Time

♦ Factory Keyless Upgrade Inputs (Allows Starting From Factory Keyless Entry

Unit)

♦4 Auxiliary Outputs To Allow Control Of A Factory Alarm

♦Diesel Glow Plug Preheat Mode select

CAUTION!

Be certain that the vehicle is outdoors before using this or any

remotevehicle startingdevice. Arunning engineproduces danger-

ous carbon monoxide fumes which can be harmful or fatal if pro-

longedexposure occurs. DONOTremote start thevehicleif thecar

isgaraged.

128-8496

2 of 4

Page2

This Remote Start Upgrade unit is designed to be added to an existing remote

control keyless entry system, or remote alarm system.

Because it is an upgrade unit it can be wired to operate from any unused button(s)

from your keychain transmitter. Please check with your installing dealer for which

transmitter button is connected to your remote start unit and, if you require a

single, double, or sequential press of the button(s) to operate your system.

SAFETY(RedHandled)CONTROLSWITCH

The control switch allows you to temporarily disable the remote starting function

of your Remote Start System. To disable the unit, move the red handled control

switch to the off position.

The control switch also allows you to select between automatic 2 hour start up

or 4 hour start up when using the automatic start up timer mode. The factory

preset start up time for this mode is every 4 hours. To select between 2 or 4 hour

start up timer:

1.Begin with the control switch in the on position

2.Turn the ignition switch on then off

3.Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to

select a 2 hour start timer. After 10 seconds expire, the parking lights will

flash 2 times confirming that the two hour start cycle is set. Or, within 10

seconds move the control switch off, on, off, on, off, on, off, on (4 switch

cycles) to select a 4 hour start timer. The parking lights will flash 4 times

confirming that the 4 hour start timer is set.

REMOTESTARTINGTHEVEHICLE

The System WILL NOT start the vehicle if any one of the following conditions

exists:

1.The Vehicle Hood Is Opened.

2.The Gear Selector Is In Any Gear Other Then Park.

3.The Brake Is Depressed.

4.The Safety Control Switch Is In The Off Position.

CAUTION! Be certain that the vehicle is outdoors before using this or any remote

vehicle starting device. A running engine produces dangerous carbon monox-

ide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT

remote start the vehicle if the car is garaged.

128-8496

3 of 4

Page3

To Remote Start The Vehicle:

Press and release the proper button or combination of buttons on your keychain

transmitter to activate the remote start system. The vehicle will start and

remain running for the pre-programmed 10 or 15 minutes. As a visual indica-

tion, the parking lights will flash or turn on dependent on the programming setup

by your installation center.

When you arrive at your vehicle, unlock the vehicle by pressing and releasing the

unlock button of your keychain transmitter or by use of the vehicle key. Enter the

vehicle and turn the ignition key to the on position.

CAUTION! Do not turn the key to the start position. This will cause the starter motor

to engage with the already running engine which could result in dam-

age. Step on the brake pedal to disengage the remote start unit. The

vehicle will continue to run on it's own power.

NOTE: The engine will stop running before the expiration of the pre-pro-

grammed run timer if you complete any of the following:

1.Pressing the proper button or buttons of your keychain transmitter while run-

ning under control of the remote start system will turn the vehicle off.

2.Depress the brake pedal.

3.Open the hood.

4.Move the red handled control switch to the off position.

5.Race the engine to above 4000 RPM.

OPERATINGONAUTOMATIC STARTUPTIMER MODE

The system has the ability to automatically start the vehicle every 2 or 4 hours

over a 48 hour period. This feature is especially useful in cold climates where

the only means to keep the engine and engine fluids warm is to periodically start

the engine.

CAUTION! Be certain that the vehicle is outdoors before using this or any remote

vehicle starting device. A running engine produces dangerous carbon mon-

oxide fumes which can be harmful or fatal if prolonged exposure occurs.

DO NOT remote start the vehicle if the car is garaged.

128-8496

4 of 4

Page4

FUNCTIONSETTING CHART

To be completed by installer

Lights Steady Pulse 

Run Time 10 Min. 15 Min. 

TOBEGINTHEAUTOMATIC STARTUPTIMER

1.Turn the ignition key on then off.

2.Within 10 seconds, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

The vehicle, on a 2 or 4 hour interval basis, will automatically start, run

for the pre-programmed time (10 of 15 minutes), and then shut off. This will

continue for 48 hours.

NOTE: The automatic start up timer can also be initiated from the keychain

transmitter.

To do this:

1.Start the vehicle using the keychain transmitter by pressing and releasing the

remote start transmitter button'(s).

2.Shut off the vehicle using the keychain transmitter by pressing and releasing

the remote start transmitter button'(s).

3.Within 10 seconds of step 2, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

CANCELINGTHEAUTOMATIC STARTUPTIMER

To cancel the automatic start up timer do one of the following;

1. Start the vehicle manually with the use of the ignition key and depress the

brake pedal.

2. Remote start the vehicle using your keychain RF transmitter.

And then

3. Shut off the vehicle using the keychain RF transmitter.

Indice

Altri manuali Audiovox Avviamento remoto

Audiovox

Audiovox 1286994 Manuale utente

Audiovox

Audiovox Pursuit Series Manuale utente

Audiovox

Audiovox APS620 - Prestige Remote Start Manuale utente

Audiovox

Audiovox Prestige APS-55LR Manuale utente

Audiovox

Audiovox Prestige Platinum+ APS 686 Manuale utente

Audiovox

Audiovox AX 901 Manuale utente

Audiovox

Audiovox PRO9246FT3 Manuale utente

Audiovox

Audiovox APS-687a Manuale utente

Audiovox

Audiovox Prestige APS-55 Manuale utente

Audiovox

Audiovox Prestige APS-57 Manuale utente

Audiovox

Audiovox Auto Security AS-9501a Manuale utente

Audiovox

Audiovox Prestige Platinum APS-57N Manuale utente

Audiovox

Audiovox CA440SS Manuale utente

Audiovox

Audiovox Pursuit PRO 9171FT Manuale utente

Audiovox

Audiovox Pursuit PRO-9671FT Manuale utente

Audiovox

Audiovox AS 9075a Manuale utente

Audiovox

Audiovox PurSuit PRO-9056TW Manuale utente

Audiovox

Audiovox Pursuit PRO-9175FT Manuale utente

Audiovox

Audiovox Pursuit PRO9051i Manuale utente

Audiovox

Audiovox Pursuit PRO-9776 Manuale utente

Audiovox

Audiovox Prestige APS-920 Manuale utente

Audiovox

Audiovox PurSuit PRO-9056TW Manuale utente

Audiovox

Audiovox APS687 - Car Prestige Remote Start Manuale utente

Audiovox

Audiovox AA-RS5CS Manuale utente

Manuali Avviamento remoto popolari di altre marche

AstroStart

AstroStart 803U Manuale utente

Durite

Durite 0-649-20 Manuale

EINHELL

EINHELL BT-PS 1000 Manuale

Linear

Linear ACCESS AK-21 Specifiche tecniche

Soundstream

Soundstream TARANTULA RS.2 Manuale utente

Jaycar Electronics

Jaycar Electronics MB3752 Manuale utente

Ultra Start

Ultra Start 72 Series Manuale utente

ADS

ADS FLASHLOGIC FLRSVW1 Manuale utente

Selecta

Selecta JS012 Manuale utente

Black Widow Security

Black Widow Security BW RAS 400 Manuale utente

Vector

Vector Power City DK080706 Supplemento

Code Alarm

Code Alarm CA-535 Manuale utente

Ozito

Ozito OJS-800 Manuale utente

Profi-Partner

Profi-Partner 46387 Manuale utente

EZ STARTER

EZ STARTER EZ-45 Manuale utente

Viper

Viper 4204 Manuale utente

Essex Electronics

Essex Electronics KE-1701 Manuale utente

EINHELL

EINHELL EGS 3600 Manuale