English8
Side burner lighting instructions
1. Once the grill burner has been lit, the side burner can be
lit by following the instructions below.
2. Open the side burner lid before lighting the side burner
and turn the side burner control knob to the ‘O’ position.
3. Push down the side burner control knob and keep
pressing whilst turning anti-clockwise to the full rate
position, an audible click will be heard, this will light the
burner. If the burner does not light, repeat this process.
4. If the burner has not lit after two attempts, turn OFF the
gas tap, wait 5 minutes and then repeat step 3 in main
burner lighting instructions.
5. When the burner has lit, the burner rate can be adjusted
by pushing down and turning the knob anti-clockwise to
any position between the full and low rate position.
6. To turn the barbecue side burner off, turn the cylinder
valve or regulator switch to the ‘O’ position and then turn
all of the control knobs on the barbecue clockwise to the
‘O’ position untill the flames have been extinguished
Warning: If the burner fails to ignite, turn the control knob
to the ‘O’ position (clockwise) and also turn the cylinder
valve off. Wait five minutes before attempting to relight
with ignition sequence.
Connecting the gas cylinder to the appliance
´This appliance is only suitable for use with low-pressure
butane or propane gas and fitted with the appropriate
low-pressure regulator via a flexible hose. The hose
should be secured to the regulator and the appliance
with hose clips/nuts. This barbecue is set to operate a 28
mbar regulator with butane gas, and a 37mbar regulator
with propane gas, and a regulator with butane/propane
mixture at 37mbar, and a regulator with butane/propane
mixture at 50mbar and a regulator with butane/propane
mixture at 30mbar. Use a suitable regulator certified to
BSEN 16129: 2013. Please consult your LPG dealer
for information regarding a suitable regulator for the gas
cylinder.
To check for leaks
´Before use please check for leakage! Never check for
leaks with a naked flame, always use a soapy water
solution.
1. Make 2-3 fluid ounces of leak detecting solution by
mixing one part washing up liquid with 3 parts water.
2. Ensure the control valve is “OFF”.
3. Connect the regulator to the cylinder and ON/OFF valve
to the burner, ensure the connections are secure then
turn ON the gas.
4. Brush the soapy solution on to the hose and all joints. If
bubbles appear you have a leak, which must be rectified
before use.
5. Retest after fixing the fault. Turn OFF the gas at the
cylinder after testing.
6. If detected leakage can not be rectified, do not attempt to
cure leakage but consult your gas dealer.
Operation
