Keys and Indicator Lamps
Keys
RESET：System reset key, and system reset will not affect network series connection
FUNC：Functional keys can be used to restore the factory setting, enter the configuration
mode, and switch lighting status in operation, etc.
Indicator Lamps
➢The indicator lamp flashes in red several times after power-on
➢After device startup, the indicator lamp turns white for about three secs. During this
period, press the FUNC key, it will enter the configuration mode.
➢The indicator lamp is green under normal mining condition.
➢The indicator is yellow during system preparation.
➢The indicator lamp is red when the system is overheated.
➢During system operation, the indicator lamp turns white by FMS software or manually
pressing the FUNC key, and the lamp reset to original color after press the Key again.
Restore to factory settings: Press the FUNC function key when power on for five seconds till the
white lamp flickers that means the success., and then press the RESET or power to restart.
Work Mode
The device has two work modes: “normal mode” and “configuration mode”.
Normal Mode
In normal mining mode, the device runs in this mode most of its life cycle, which network can
use DHCP (dynamic acquisition) or static IP, and the default is set to DHCP.
