AVer AVerVision VP-1HD Guida all'installazione

VP-1HD FAQ

There is no picture on the presentation screen.

1. Check all connections again as shown in the user manual.

2. Verify the setting of the display output device; make sure it is set to the right

input/channel.

3. If you have a laptop connected to the document camera and cannot see the

desktop on the presentation screen, please make sure to set your laptop to dual

screen display mode.

4. Check the TV/RGB switch on the side of the camera and set it accordingly to your

display device type.

I have set up the VP-1HD and checked all the connections as specified in

the user manual but I cannot get a picture on the preferred presentation

screen.

1. The unit’s power button turns Red in standby mode. Press the POWER button

again to turn and the LED light will turn Green.

2. The default camera display resolution setting is on 1024X768. If your output

device does not support this resolution; Adjust the resolution dip switch on the

side of the document camera accordingly.

3. If your output device is a TV or any analog device, please switch the TV/RGB dip

switch to TV.

The picture on the presentation screen is out of focus.

1. Check your output device’s focus adjustment.

2. Press the auto focus button on your document camera’s control panel.

3. Power-cycle your camera.

There is no computer signal on the presentation screen.

1. Check all cable connections among the display device, VP-1HD and your PC,

replace cables if necessary.

2. Connect your PC to the VP-1HD first before you power on your computer.

3. Make sure to switch your Laptop to dual screen display mode by holding Fn and

repeatedly toggling the F5 key. For different command, please refer to your

laptop manual.

Can you use the AVervision software with the VP-1HD ?

1. Yes. The VP-1HD have a USB port therefore you can connect this camera to your

computer to use the Software.

Is there a light source on the VP-1HD ?

1. No. The VP-1HD does not have a built in lamp, it uses ambient light in your

environment.

The brightness on the presentation screen is dark and unreadable

1. Press the Brightness level control buttons on the control panel to adjust the

brightness.

2. Make sure there is sufficient lighting in the room.

3. Your projector’s bulb may need to be changed.

Altri manuali per AVerVision VP-1HD

1

Indice

Altri manuali AVer Telecamera per documenti

Manuali Telecamera per documenti popolari di altre marche

Lumens

Lumens PS760 Manuale utente

Genee World

Genee World GV8100 Manuale utente

Touchboards

Touchboards Vidifox DV 480 Manuale utente

Dukane

Dukane 210 Manuale utente

TTS

TTS Easi-View Pro Manuale utente

Lumens

Lumens dc153 Manuale utente

Avermedia

Avermedia AVerVision SPB350 Manuale utente

Inswan

Inswan INS-3 Manuale utente

Genee

Genee Vision 6100 Manuale utente

Rolls

Rolls DB14 - 02/10 Manuale utente

Lumens

Lumens DC-W80 Manuale utente

Dukane

Dukane FASTFAX AV-P750U Manuale utente

Optoma

Optoma DC554 Manuale utente

Ipevo

Ipevo Ziggi Manuale utente

Vidifox

Vidifox PV 380 Manuale utente

Recordex

Recordex SimplicityCam SC5i+ Manuale tecnico

Ken A Vision

Ken A Vision TeachCam 910-171-150 Manuale utente

Avermedia

Avermedia AVerVision SPC300 Manuale utente