41.1 Safety and warnings
XM Preview Guide
1
1.1 Safety and warnings
Safe Installation
The mains lead must be connected to a supply outlet with a protective
earth contact. The electrical supply at the socket outlet must provide over-
current protection of an appropriate rating.
Pluggable equipment must be installed near an easily accessible socket
outlet. Permanently connected equipment must have a readily accessible
disconnect device incorporated in the fixed wiring.
To avoid the risk of the machine falling, where applicable, ensure that it is
placed securely on a flat and level surface.
USA
If the scale is connected to a 240V supply, the receptacle must be
protected by a 15amp circuit breaker.
Safe use
To avoid the possibility of electric shock or damage to the machine, always
switch off the machine and isolate from the power supply before carrying
out any routine maintenance.
Cleaning the machine
CAUTION: Harsh abrasives, solvents, scouring cleaners and alkaline
cleaning solutions, such as washing soda, should not be used especially on
the display windows. Under no circumstances should you attempt to wipe the
inside of the machine.
The outside of standard products may be wiped down with a clean cloth
moistened with water containing a small amount of washing up liquid.
Safety
To avoid the possibility of electric shock or damage to the machine, always
switch off the machine and isolate from the power supply before carrying
out any routine maintenance.
Training
Do not attempt to operate or carry out any procedure on a machine or
network unless you have received the appropriate training or read the
instructions books provided.
Ergonomics
To avoid the risk of RSI (Repetitive Strain Injury) it is important to ensure
that the machine is placed on a surface that is ergonomically satisfactory
to the user. It is recommended that frequent breaks are taken during
prolonged usage.
EMC compliance
This is a class A product. In a domestic environment, this product may
cause radio interference in which case the user may be required to take
adequate measures.
Cleaning the print head
CAUTION: Do not use metallic objects on the print head. Only use the
recoommended print head cleaning kit.
