AVLink HDMI-E8 Manuale utente
Distribution Amplifier (DA)—User Manual
User Manual
Distribution Amplifier
1x8 /1x16
HDMI-E8 / HDMI-E16
V.2012HDMI-E8E16.00
Copyright and Trademarks:
All rights reserved by C&C TECHNIC TAIWAN CO., LTD. No part of this document may
be reproduced in any form or by any means without written permission from the product
manufacturer. Changes are periodically made to the information in this document.
They will be incorporated in subsequent editions. The product manufacturer may make
improvements and /or changes in the product described in this document at any time.
All the registered trademarks referred to this manual are belonging to their respective
companies.
Distribution Amplifier (DA)—User Manual
1
Before You Begin
Follow all instructions marked on the device during using.
Do not attempt to maintain the device by yourself, any faults, please contact your
vendor.
Provide proper ventilation and air circulation and do not use near water.
It is better to keep it in a dry environment.
The system should be installed indoor only. Install either on a sturdy rack or desk in a
well-ventilated place.
Only use the power cord supported with the device.
Do not use liquid or aerosol cleaners to clean the device.
Always unplug the power to the device before cleaning.
Unplug the power cord during lightning or after a prolonged period of non-use to avoid
damage to the equipment.
Distribution Amplifier (DA)—User Manual
2
Table of Contents
1. System Overview ........................................................................................................................4
1.1 Introduction.......................................................................................................................4
1.2 Packing..............................................................................................................................5
1.3 Accessories (Optional) ......................................................................................................5
2. Features .......................................................................................................................................6
3. Specifications..............................................................................................................................7
4. Device Installation.......................................................................................................................8
5. Front/Rear Panels........................................................................................................................9
5.1 Front Panel ........................................................................................................................9
5.2 Rear Panel .......................................................................................................................10
6. Peripherals Connections............................................................................................................12
6.1 Input/Output Connections...............................................................................................13
6.1.1 Output LED..........................................................................................................14
6.1.2 Output Cable ........................................................................................................14
6.2 IR Pass-through Connection............................................................................................15
6.3 IR EXT Connection.........................................................................................................16
6.4 Power Connection...........................................................................................................16
6.5 Distribution Amplifier Remote Control ..........................................................................17
6.6 Ports and Switchers.........................................................................................................18
6.6.1 RS-232..................................................................................................................18
6.6.2 RS-485..................................................................................................................20
6.6.3 LAN Port..............................................................................................................22
6.6.4 DIP Switcher 8 Pins .............................................................................................23
6.6.5 DIP Switcher 2 Pins .............................................................................................23
6.6.6 Device ID Settings ...............................................................................................24
7. Application Software.................................................................................................................26
7.1 Software Introduction......................................................................................................26
7.1.1 Software Description............................................................................................26
7.1.2 Software Activation..............................................................................................26
7.1.3 Connect Distribution Amplifier and PC...............................................................27
7.2 Configuration ..................................................................................................................27
7.2.1 Main Operation Interface.....................................................................................29
7.2.2 Disconnect Function Key.....................................................................................31
7.2.3 Audio Configuration Function (Not Support for DA)..........................................33
7.2.4 EDID Configuration Function (Not Support for DA)..........................................36
7.2.5 RS-232 Memory Function (Not Support for DA)................................................37
7.2.6 Options Function..................................................................................................38
7.2.7 Communication Protocol/Control Command Code.............................................38
Distribution Amplifier (DA)—User Manual
3
7.3 LAN Web Configuration.................................................................................................39
7.3.1 Audio Configuration (Not Support for DA).........................................................40
7.3.2 Video Configuration (Not Support for DA) .........................................................41
7.3.3 Device Status Information....................................................................................41
7.3.4 Device Output View.............................................................................................42
7.3.5 LAN Main Operation...........................................................................................42
7.3.6 LAN Memory Function (Not Support for DA)....................................................43
7.3.7 LAN IP Function..................................................................................................44
7.3.8 Other Application.................................................................................................45
8. Troubleshooting.........................................................................................................................46
Appendix A Remote Controller (Optional)...................................................................................48
Appendix B IR Mini-Controller (Optional)..................................................................................49
Appendix C Firmware Upgrade....................................................................................................50
Appendix D RS-232 Communication Protocol.............................................................................53
D-1 Host Request..................................................................................................................53
D-1.1 Device Byte.........................................................................................................53
D-1.2 Request Byte.......................................................................................................54
D-1.3 Index Byte...........................................................................................................56
D-1.4 Value Byte...........................................................................................................57
D-1.5 CRC Byte............................................................................................................58
D-2 Device ACK Packet .......................................................................................................59
D-2.1 ACK Type A........................................................................................................59
D-2.2 ACK Type B........................................................................................................60
D-2.3 ACK Type C........................................................................................................61
D-2.4 ACK Type D........................................................................................................62
D-2.5 ACK Type E........................................................................................................63
Appendix E HDMI Extender (HX-RW)........................................................................................65
Features .................................................................................................................................66
Specifications........................................................................................................................66
Installation.............................................................................................................................66
IR Receiver Cable Directions................................................................................................67
IR Blaster Cable Directions...................................................................................................67
HDMI Output Connector ......................................................................................................67
Wiring Information for Link Connector................................................................................68
Firmware Upgrade.................................................................................................................69
Distribution Amplifier (DA)—User Manual
4
1.System Overview
1.1 Introduction
HDMI-E8/HDMI-E16 Distribution Amplifier (DA) is high performance HDMI output
distribution equipment combining with video and audio. It is used for output distribution of
multimedia signals. Through a HDMI source, you can transmit the same multimedia
signals to separate output equipment, thereby minimizing signal attenuation and
ensuring high definition, integrating high fidelity graphics and audio signal output.
Through the extensible accessory devices, HDMI-E8/HDMI-E16 can transmit data or
detect signal to over long distances about 100 meters with HDMI extender (HX-RW).
HDMI-E8/HDMI-E16 is used mainly in TV broadcasting projects, multimedia conference
halls, and large display performances, TV teaching and command control centers. It
boasts features of power interruption protection during power surge and synchronous
and integrate audio/visual switching functions. HDMI-E8/HDMI-E16 supports a HDMI
Type A for input and some RJ45 jacks for output connectors. Beside it also supports a
RS-232 or LAN communication port enables convenient communication with remote
control equipment to switch the multimedia output signals.
Figure 1-1 HDMI-E8
Figure 1-2 HDMI-E16
Distribution Amplifier (DA)—User Manual
5
1.2 Packing
Or
Distribution Amplifier (DA) * 1 (HDMI-E8 or HDMI-E16)
Power Cord * 1
IR Receiver Cable * 1
IR Blaster Cable * 1
User Manual * 1
1.3 Accessories (Optional)
HDMI Extender (HX-RW)
IR Receiver Cable
IR Blaster Cable
Remote Controller
IR Mini-Controller
AV Matrix Software CD
Distribution Amplifier (DA)—User Manual
6
2.Features
Support 1 HDMI Jack for input and 8/16 RJ45 Jacks for output interfaces
Mixed use a HDMI cable for input and Cat.5e cables for output connections
Output supports HDBaseT as a long-distance transmission via a 100m Cat.5e cable
HDCP Compliant
Support resolution up to 4K x 2K@30Hz, 8-bit or 1080P@60Hz, 12-bit
Support original 3D pass through
Support High Definition Audio (Dolby TrueHD, Dolby Digital Plus and DTS-HD MA)
IR pass-through supports all IN and OUT ports
IR pass-through supports all kinds of IR frequency band
IR pass-through supports Bi-directional transmission between IN and OUT ports
Support IR remote control
Support RS-232 control
Support RS-485 serial control
Support Ethernet control
Internal universal power supply
2U rack for HDMI-E8 and 3U rack for HDMI-E16
Distribution Amplifier (DA)—User Manual
7
3.Specifications
Hardware
Input Connector HDMI Type A x 1
Output Connector HDMI-E8: RJ45 x 8
HDMI-E16: RJ45 x 16
RS-232 Connector DB9 Female
LAN Connector RJ45
RS-485 Connector 2
2 pins Dip Switcher 1
8 pins Dip Switcher 1
Power 100VAC~240VAC, 50/60Hz, internal
Housing Black Aluminum
Mounting
Rack mountable
(2U-rack-mount kits for HDMI-E8)
(3U-rack-mount kits for HDMI-E16)
Weight HDMI-E8: 4250g
HDMI-E16: 7500g
Dimensions (LxWxH)
HDMI-E8: 332x482x87mm
HDMI-E16: 336x482x130mm
(Full rack wide without grips)
Multimedia
Max. Resolution 4K x 2K@30Hz, 8-bit
Highest TMDS Frequency 300MHz
Control Information
HDMI Cable Distance 10 meter (At least)
Cat.5e Cable Distance 100 meter (Max.)
Baud Rate 9600 bps; 8 data bits, 1 stop bit, no parity
Ethernet Protocol HTTP, DHCP, TCP/IP, ICMP (ping)
Program Control Web Server, AV Matrix Application
Serial Control Port RS-232: 9 Pin Female D Type Connector
RS-485: 1X5 Pole Captive Screw
Remote Control Remote Controller, IR Receiver, IR Blaster
Web Server LAN, RJ45
Distribution Amplifier (DA)—User Manual
8
4.Device Installation
The Distribution Amplifier (DA) has a black metallic housing. It can be placed on a sturdy
desk directly or installed on a 2U (HDMI-E8) or 3U (HDMI-E16) 19in bracket. See below:
Figure 4-1 Mount the Device on a Standard Bracket with 2U Rack-mount
(HDMI-E8)
Figure 4-2 Mount the Device on a Standard Bracket with 3U Rack-mount
(HDMI-E16)
Distribution Amplifier (DA)—User Manual
9
5. Front/Rear Panels
5.1 Front Panel
Figure 5-1 HDMI-E8 Front Panel
Figure 5-2 HDMI-E16 Front Panel
HDMI-E8/HDMI-E16 supports a power LED indicator on the Front Panel allowing you to
detect power status.
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali AVLink Amplificatore
AVLink
AVLink HS-1614W Manuale utente
AVLink
AVLink HS-2314FS Manuale utente
AVLink
AVLink HS-2414FS Manuale utente
AVLink
AVLink SA-2 Manuale utente
AVLink
AVLink VS-914UF Manuale utente
AVLink
AVLink 12S-104 Manuale utente
AVLink
AVLink HS-E Series Manuale utente
AVLink
AVLink HS-1512IW Manuale utente
AVLink
AVLink 128.513UK Manuale utente
AVLink
AVLink 12G-SDI Manuale utente
