Axon Body 2 Manuale utente
Axon Body 2 Camera
User Manual
Model AX1001
IMPORTANT SAFETY INSTRUCTIONS
Read all warnings and instructions. Save these
instructions.
The most up-to-date warnings and instructions are
available at www.axon.com
MMU0057 Rev: G
Contents
i
1Chapter 1: Introduction
1 What Is the Axon Body 2 Camera System?
1 Important Safety and Health Information
1 Additional Reading
2Chapter 2: Getting to Know Your Axon Body 2 Camera
4 Accessories
5Parts
5Assembly and Use
7Chapter 3: Recording with the Axon Body 2 Camera
7 Operating Modes
7 BUFFERING Mode (Turning on the Camera)
8 EVENT Mode (Starting Recording)
8 Muting Audio Recording
9 Adding Markers to Recorded Video
9 Battery Status
9 Configuring Your Axon Camera
9 Adjusting the Audio Prompt Volume
9 Turning o the Camera LEDs (Stealth Mode)
10 Using Axon View
10 Pairing Your Axon Body 2 Camera with a Smart Device
10 Other Settings
11 Chapter 4: Notification Reference Tables
11 Audio Prompts
12 LED Status
12 Operation LED
12 Function LED
12 Battery LED
12 Upload Status LED
ii
Axon Body 2 Camera User Manual
14 Chapter 5: Axon Signal Operations
15 Chapter 6: Care and Maintenance
15 Cleaning the Axon Body 2 Camera
15 Charging the Battery
16 Replacing the Battery
17 Chapter 7: Troubleshooting
17 Customer Service
17 Warranty Policy
17 Warnings
17 Radio Waves
19 Declaration of Conformity
19 Compliance Marks
1
Chapter 1: Introduction
What Is the Axon Body 2 Camera System?
The Axon Body 2 is a camera system incorporating an audio and video recording device. This cam-
era is designed for use in tough environmental conditions encountered in law enforcement, cor-
rections, military, and security activities. The Axon Body 2 camera is designed to record events for
secure storage, retrieval, and analysis via Evidence.com services. The recorded events are trans-
ferred to your storage solution via the Axon Dock, or by using Evidence Sync software installed
on a Windows computer.
The Axon Body 2 camera has 2 operating modes designed to accommodate the needs of law
enforcement, corrections, security, and the military. The default mode, or BUFFERING mode, pro-
vides pre-event buering to capture activities that occur prior to the user activating the EVENT
mode. In addition, the Axon View application enables playback of footage on a smart device for
review prior to storing the data.
Important Safety and Health Information
Read, understand, and follow all warnings and instructions before using this product. The most
up-to-date warnings and instructions are available at www.axon.com.
Additional Reading
This manual explains how to operate the Axon Body 2 camera hardware. Other manuals cover
additional aspects of the Axon Body 2 system. These documents are available at www.axon.com.
The Axon Academy website explains how to register for the Evidence.com website, configure set-
tings, install Evidence Sync software, assign personnel to cameras, recharge your camera, and
transfer video from an Axon device to a computer. Visit academy.axon.com.
Detailed instructions for using Axon cameras and other Axon products with Evidence Sync are
available in the Evidence Sync User Manual.
For instructions on using Axon cameras with a smart device, see the Axon View for Android De-
vices User Manual or the Axon View for iOS Devices User Manual.
If you have an Axon Dock, see the Axon Dock Quick Start Guide for how to transfer information
and recharge your camera.
2
The Axon Body 2 camera includes physical controls to enable video and audio capture while pro-
viding visual, audible, and vibration notifications of the Axon Body 2 camera’s state of operation.
Operation LED
Shows the camera’s current operating mode (for battery status, see the Battery LED, described
below).
Operating Mode Operation LED
Recording
Recovering interrupted video*
Blinking red
Buering Blinking green
Booting up/powering down
Error state**
Solid red
*When the Function LED also is blinking red.
** When the Function LED also is solid red.
upload status LED
bottom viewtop view
Function LED Operation LED
connection socket
Function button
lens
on/off switch
on/off indicator
dual-channel microphone
speaker
EVENT button
Battery LED
front view
Battery status button
Chapter 2: Getting to Know Your Axon Body 2
Camera
Chapter 2: Getting to Know Your Axon Body 2 Camera 3
Axon Body 2 Camera User Manual
Function LED
Shows when certain functions are enabled.
Function Enabled Function LED
Mute Blinking blue
Camera error*Solid red
Bluetooth feature is booting up Solid blue
Wireless accessory configuration (WAC) Blinking magenta
*Use the power switch to turn the camera o and on.
Connection Socket – Enables data transfer and recharging.
On/O Switch – Turns the camera’s power on or o.
On/O Indicator – When the camera’s power is turned on, the red portion is exposed. When the
camera power is turned o, the red portion is covered from view.
Speaker – Provides audio notifications.
Function Button – Used in device pairing, to mute the device, and to add markers to the video as
it is recorded.
EVENT Button – Used to start and stop recording. (Double-press to start; hold for 4 seconds to
stop recording.)
The camera might take several additional seconds to close out of the video when it is powered o
before stopping an event.
Battery Status Button – When pressed, the Battery button lights up the Battery LED, which mo-
mentarily indicates the remaining battery capacity only (with default settings, the Battery LED
does not indicate the operating mode).
Battery LED
When lit, momentarily indicates the remaining battery capacity (with default settings, it does not
indicate the operating mode).
When you turn the camera on, the Operation LED turns solid red until the system is ready to use.
Then the Operation LED blinks green (BUFFERING mode). The camera can be configured so the
Battery LED operates in sync with the Operation LED. In BUFFERING mode both the Operation
and Battery LEDs will blink green, and in EVENT mode both will blink red. If the battery status
button is pressed, the battery LED displays the battery status for approximately 10 seconds and
then resumes displaying the EVENT mode.
Battery Status Battery LED
Battery capacity is 41–100 percent Green
Battery capacity is 20–40 percent Yellow
Battery capacity is less than 20 percent Red during operation; ashing red and yellow during
charging
Battery is critically low Blinking red and yellow
Chapter2:Getting to KnowYour AxonBody 2Camera 4
Axon Body 2 Camera User Manual
Battery Status Battery LED
BUFFERING mode (if configured) Blinking green
EVENT mode (if configured) Blinking red
Dual-Channel Microphone – For audio recording.
Upload Status LED
Indicates status when the camera is uploading data to the Evidence.com website via the Axon
Dock.
System Status Upload Status LED
Initial connection (momentary) Solid red (for 20 seconds or fewer)
In queue awaiting upload Solid yellow
Device ready (all videos uploaded successful-
ly) and fully charged
Solid green
Device not assigned, agency mismatch, cam-
era set in the oine mode, or device error
Blinking red
Uploading data Blinking yellow
Firmware update, internal battery charging,
extremely low battery, or memory full
Blinking red and yellow – DO NOT remove the
camera from the Axon Dock
Transfer error, device re-trying to transfer Blinking green and yellow
Network error (no connection) Blinking red, yellow, and then green (cycling all
colors)
Axon Dock has no communication with the
camera. Contact Axon customer service.
LED o
Lens – The camera lens.
Pressing buttons causes the Axon Body 2 camera to emit audio alerts (beeps) to indicate system
actions. See Chapter 4: Notification Reference Tables for more information.
Accessories
The Axon Body 2 camera is designed to work with the new Axon RapidLock mounting system.
The Axon RapidLock mounting system consists of the attachment piece (called the key) on the
camera and the various mounting options including the attachment receiver (called the lock). To
engage the Axon RapidLock, insert the key of the camera into the lock of the mount and turn it
90 degrees counterclockwise (when you are looking straight at the mount). To release the camera
from the mount, turn the camera 90 degrees clockwise.
The various mounts that use this system can be used with a wide variety uniforms, and holds the
camera to your shirt, patrol vest, jacket, or belt.
Chapter 2: Getting toKnow Your AxonBody 2 Camera 5
Axon Body 2 Camera User Manual
Parts
Assembly and Use
Read Important Safety and Health Information (Chapter 1) before performing these steps.
1 Insert the key on the back of the Axon Body 2 camera into the lock.
2 Twist the Axon RapidLock mount counterclockwise, 90 degrees.
3 Place the magnetic back underneath the shirt, patrol vest, or whatever you are using.
4 Hold the back in place, and place the Axon RapidLock mount over the back. Magnetic at-
traction will hold the camera in place.
back lock camera
1 2
3 4
Chapter2: Getting to KnowYourAxon Body2Camera 6
Axon Body 2 Camera User Manual
When you are wearing the camera, you can use the Axon View application’s live streaming feature
to determine whether your camera is capturing the view you intended.
7
Chapter 3: Recording with the Axon Body 2
Camera
Before using an Axon Body 2 camera, ensure it is fully charged and connect it to Evidence.com
via the Axon Dock or Evidence Sync software to ensure it is properly configured. See Battery
LED (Chapter 2) and Charging the Battery (Chapter 6) for more information.
Operating Modes
The Axon Body 2 camera has 2 operating modes:
1 BUFFERING (turning on the camera and starting pre-event buering)
2 EVENT (event recording)
BUFFERING Mode (Turning on the Camera)
1 Move the ON/OFF switch on the camera to the ON position.
With the camera turned on, the Axon system is in the BUFFERING mode. When BUFFERING be-
gins:
• The Operation LED on the camera will blink green.
• The camera will be capturing video but no audio, and will not record to permanent memory
while in BUFFERING mode.
• Buered video duration is 30 seconds by default (00:00:30).
When you activate the EVENT mode, the buered video (not audio) captured directly before the
event, up to 30 seconds, will be saved and attached to the event in permanent memory. This fea-
Altri manuali per Body 2
6
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Axon Accessori
