Ayrton AYD-20 Manuale utente

AYD-20

Dehumidifier

User manual

Original

Operation Area

This dehumidifier is intended for indoor residential applications only.It should not be used for

commercial or industrial applications.

Place the dehumidifier on a smooth and level floor.

A dehumidifier operating indoor will have no effect in drying an adjacent enclosed area,

such as a closet.

Place the dehumidifier in an area where the temperature will not below 5 ºC or above 32 ºC.

Allow at least 30–45cm of air space on all sides of the unit.

Close all doors, windows and other outside openings of the room to improve the working

effect.

Please keep the air inlet / outlet clean and not blocked.

Do not use a dehumidifier in a bathroom.

Avoid direct sunlight.

Note:

The dehumidifier has rollers to aid placement. Do not attempt to roll the dehumidifier on carpet

or over objects. Otherwise, water may spill out from the bucket or the dehumidifier may get

stuck by the objects.

Correct Wrong

Above

5 ºC

Below

5 ºC

Safety Precautions

This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if they

have been given supervision or instruction concerning use of the appliance in a safe way

and understand the hazards involved.

Before operation, please check the power cord if it complies with the requirement indicated

on the nameplate.

Before cleaning, please turn it off and unplug the dehumidifier.

Make sure the power cord is not pressed by any hard object.

Do not remove the power plug or move unit by pulling the power cord.

Do not use any heating application near the dehumidifier.

Do not remove the power plug in wet hands.

Please use grounded power cord and make sure it's well connected and not damaged.

Children and disabled people are not allowed to use the dehumidifier without supervision.

Children shall not play with the appliance.

Keep children from playing or climbing on the dehumidifier.

Do not place the dehumidifier under dripping objects.

Memory function is included in this dehumidifier. When nobody is taking care of the unit,

please turn it off and remove the power plug or disconnect power.

Do not repair or disassemble the unit by yourself.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualified persons in order to avoid a hazard.

Cleaning and user maintenance shall not be made by children without supervision.

If abnormal condition occurs (e.g. burned smell), please disconnect power at once and then

contact local dealer.

Dehumidifier can not be disposed of everywhere. If you want to get rid of this dehumidifier,

please check with local handling disposal or information service center about what to do.

Instructions for cord-connected room air conditioners shall include manufacture’s

recommendations regarding the use of cord sets(extension cords). If use of an extension

cord is not recommended, the instructions shall state this. Recommendations for an

extension cord shall specify at least the use of a cord set with an equipment grounding

conductor grounding-type attachment plug, and grounding-type connector(load fitting); and

the amp city and voltage rating of the cord set.

Parts Name

Front Side

Back Side

CONTROL

PANEL

FRONT

GRILLE

ROLLERS

RESPIRATION

LAMP

WATER

BUCKET

AIR FILTER

POWER PLUG

Instruction of Caster Wheel

1. Nip the groove at both sides of bucket and pull the bucket out by the arrow shown

direction. (As shown in fig.a)

2. Take out accessory box (there are 4 castors).

3. Refit the bucket by the arrow shown direction, then the unit is ready to be electrified and

turned on. (As shown in fig.c)

4. Take out 4 castors from accessory box.

5. Tilt the dehumidifier no more than 45°. Aim the shaft of castor at the installation hole on

chassis, and then forcibly push the castor upward to let the locating ring on the shaft of

castor stick together with the side face of installation hole. (refer to Fig.d)

6. Install the 4 caster wheels on the dehumidifier.

NOTE:

1. Keep the dehumidifier balance during installation incase the dehumidifier falls.

2. Four caster wheels must be installed well before operating the unit.

Bucket

Accessory box

Fig. a Fig. b Fig. c

Locating ring

on the shaft

of castor

Fig.d

Check Before Operation

Before operation, please first check whether float is properly placed.

Below are the checking steps:

1. Hold the handles on both sides of the water bucket and pul lit out following the arrow

direction.

2. Check whether float in the water bucket is properly placed. It might have been moved a

little after long-time transportation. If it's not placed properly, move it to the correct position

by hand.

Correct Position Wrong Position

3. Replace the bucket as instructed in step 1.

Float

Operation Method

Clean the filter

indicator light

Lock on

indicator

light

High, mid and low

fan indicator light

Living

space

mode

indicator

light

Sleeping

space

mode on

indicator

light

Bucket full

light indicates

bucket needs

to be emptied

or it is not in

the proper

place

Power on

indicator

light

Notes:

Water bucket must be correctly installed for the dehumidifier to operate.

Do not remove the bucket while unit is in operation.

If you want to use drain hose to drain water away, please install the hose according to

section "Drainage method".

Each time pressing the effective button on the control panel will give out a "beep" sound.

When power is connected, power indicator on the control panel will be on and dehumidifier

gives out a "beep" sound simultaneously.

Basic Functions of the Buttons



POWER Button

Press this button to turn on / off dehumidifier.



+/- Button

Under free drying mode press these buttons to adjust set humidity. Invalid under other

modes.

Pressing + button will increase humidity while pressing - button will decrease

humidity. The display range of humidity is 35%~80%. Each pressing will

increase/decrease humidity by 5%.

When setting Timer On or Timer Off, press these buttons to adjust time. For specific

details, please refer to Timer Button description below.

When unit is in operation, holding + and - button simultaneously for 3s can

lock buttons. If this function is turned on, Button Locked Indicator will be on and display

window shows LC, which will blink for 3 times. Then ambient humidity is displayed

again. To turn off this function, hold + and - button simultaneously for 3s and the

indicator will be off.

Continuous

operation on

indicator

light

Basement

mode on

indicator

light

Timer

indicator

light



FAN SPEED Button

Pressing this button can set fan speed circularly as: High, Medium, Low. Corresponding

indicator will be on for each fan speed.



TIMER Button

Press this button to set Timer On or Timer Off (Timing range 0.5~24h).

Set Timer Off:

When unit is on, press this button and the Timer Indicator will be blink while display

window will show the timing figure. Pressing + or –button each time will increase or

decrease the time by 0.5h or 1h (When figure varies within 10h, pressing +/- button

will increase/decrease the time by 0.5h; when figure varies from 10h to 24h, pressing

+/- button will increase/decrease the time by 1h). When time is set, wait for 5s or

press this button to turn this function on. Timing Indicator will be on.

Cancel Timer Off:

Under the condition that this function is turned on, press this button to cancel it.

Timing Indicator will be off.

Set Timer On:

When unit is off, press this button and the Timer Indicator will be blink while display

window will show the timing figure. Pressing + or –button each time will increase or

decrease the time by 0.5h or 1h (When figure varies within 10h, pressing +/- button

will increase/decrease the time by 0.5h; when figure varies from 10h to 24h, pressing

+/- button will increase/decrease the time by 1h). When time is set, wait for 5s or

press this button to turn this function on. Timing Indicator will be on.

Cancel Timer On:

Under the condition that this function is turned on, press this button to cancel it.

Timing Indicator will be off.

Timing range: 0.5~24 hours.



MODE Button

Press this button to select different kinds of working mode. After each pressing of this

button, mode will switch among free drying, sleeping space, living space, basement and

continuous drying modes, and the corresponding mode indicator will ON. When free

drying, all mode indicators are OFF.



CONTINUOUS button

Press this button to set continuous dehumidify.

Note: When selecting CO mode, drain hose has to be installed. Otherwise, unit will stop

when water bucket is full.



FILTER Button

Press this button to turn off Filter Cleaning Indicator. (When dehumidifier has been

operating for 250 hours, Filter Cleaning Indicator will be lit up to remind user of filter

cleaning.)

Other Instructions

1. Alarm Warning

If bucket is full or not locked into place for over 3min, buzzer will go off for 10s to remind

you to empty bucket or put it back into the correct place.

2. Auto Stop

When bucket is full, removed or not placed correctly or the humidity is 5% lower than the

set humidity, unit will automatically stop.

3. Memory Function

If power is lost, all of the control settings are remembered. So when power is restored, the

unit will start back up in the settings it was in when power was lost.

4. Bucket full light

This indicates that bucket is full or removed or not placed correctly.

5. Clean the Filter On indicator light

When dehumidifier has been operating for 250 hours, Filter Cleaning Indicator will be lit up

to remind user of filter cleaning.

6. Respiration Lamp

This lamp will continually blink to show the bucket is full, removed or not placed correctly.

Indice

Altri manuali Ayrton Deumidificatore

Ayrton

Ayrton AYD-12 Manuale utente

Manuali Deumidificatore popolari di altre marche

Daitsu

Daitsu CD031IU-DFA Manuale utente

Fehom

Fehom PDGT701BE Manuale utente

Hitachi

Hitachi RD-190GX Manuale utente

Westpoint

Westpoint MDF1-30AE Manuale utente

SOLIS

SOLIS easy dry compact Manuale utente

ENVIROBOSS

ENVIROBOSS EB240 Manuale utente

Sinclair

Sinclair R-9112 Manuale utente

Kenmore

Kenmore 580.54701 Manuale utente

Demargo

Demargo DM828NF Manuale utente

Altrad Lescha

Altrad Lescha LDH 600 Manuale utente

BOMANN

BOMANN LE 1150 CB Manuale utente

SPT

SPT SD-46 Manuale utente

REMKO

REMKO SLN 40 Manuale utente

Haier

Haier HD458 Manuale utente

Logik

Logik L20DHW12 Manuale utente

Frigidaire

Frigidaire FDR30S1 - 30 Pint Capacity Dehumidifier Guida rapida

Blitz

Blitz HHD Series Manuale utente

Prem-I-Air

Prem-I-Air PD14DEN Manuale utente