Aztech SC16-3D Manuale utente
SC16-3D
Users Manual
Version 1.0
SC16-3D Sound Card Users Manual
2
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
©Copyright Aztech Systems Ltd
The software described in this manual is protected by international copyright laws. Under this copyright law, you are
prohibited from duplicating the software for any purpose other than making archival copies for the sole purpose of
backing-up against loss.
In addition, no part of this manual may be reproduced or transmitted, in any form or by any means, electronic or
mechanical, including photocopying, recording, or information storage and retrieval systems, for any purpose other
than the purchasers personal use, without the prior written permission of Aztech Systems Ltd.
Microsoft, MS-DOS, Windows and Windows NT are registered trademarks of Microsoft Corp.
Sound Blaster is a registered trademark of Creative Technology Ltd.
Voyetra is a registered trademark of Voyetra Technologies Inc.
All other company or product names are trademarks or registered trademarks or service marks of their respective
owners and are hereby recognized as such.
Disclaimer Statement
Aztech Systems Ltd specifically disclaims all warranties, either expressed or implied, including but not limited to
implied warranties of merchantability and fitness for a particular purpose, with respect to the hardware, software, and
the accompanying written materials. Aztech Systems Ltd reserves the right to revise or make improvements to its
product at any time and without obligation to notify any person of such revisions or improvements.
In no event shall Aztech Systems Ltd be liable for any consequential or incidental damages, including any loss of
business profits or any other commercial damages, arising out of the use of its product.
Printed in Singapore
P/N: 040-002367-102
3
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
SC16-3D Sound Card Users Manual
ENGLISH
Table of Contents
Setting Up Your Sound Card....................
1.1 Minimum System Requirements..........................
1.2 Safety Precaution...................................................
1.3 Installation Notes....................................................
1.4 Installing the Sound Card......................................
1.5 Connecting the Sound Card..................................
Installing the Sound Card Drivers
and Utilities...............................................
Frequently Asked Questions....................
Technical Specifications..........................
Sound Card Layout...................................
5
6
7
8
12
13
19
21
23
6
SC16-3D Sound Card Users Manual
4
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
This page has been intentionally left blank.
5
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
Setting Up Your Sound Card
Thank you for buying the SC16-3D Sound Card.
With its many high-fidelity features including Full Duplex audio drivers and
compliance to major sound standards in the industry, the SC16-3D Sound Card
provides the ultimate PC audio performance.
In addition, your sound card package comes with a comprehensive set of software
applications that allow you to add the impact of sound to virtually every computing
tasks. From adding voice annotations to your documents to creating multimedia
applications, your sound card and its bundled software will greatly enhance your office
productivity and home entertainment.
SC16-3D Sound Card Users Manual
6
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
1.1 Minimum System Requirements
§PC-based computer.
§ISA Bus slot.
§640KB RAM on-board for computers running DOS (2MB RAM and
above for computers running Windows®3.1 and above).
§10MB hard disk space (system files and audio drivers only).
§CD-ROM drive.
§DOS 3.0, Windows®3.1, Windows®95 or Windows NT® 4.0.
1.2 Safety Precaution
§Do not remove your sound card from its protective bag until you are
ready to install it.
§Always try to hold your sound card by its edges. Avoid touching any
electronic components on your sound card.
§Static electricity can cause permanent damage to your sound card. To
prevent such a damage, you must ground yourself while installing the
card. You can do this in either of two ways :
»Use a grounding strap, which is a coiled wire with a clip at one
end and an elastic strap at the other. Wear the strap around your
wrist and attach the clip to any non-painted metal surface of the
computers chassis.
»If you do not have a grounding strap, touch any non-painted
surface of the computer's chassis before you begin installation,
and again every minute or so until the installation is completed.
7
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Chapter 1 Setting Up Your Sound Card
ENGLISH
1.3 Installation Notes
§Computers come in different shapes and sizes. Therefore, the
installation procedures in this chapter apply generally and you should
compare the illustrations here with your computer before you start the
sound card installation.
§A Philips-type Screwdriver is required for the sound card installation.
§Your computers documentation should come in handy during the
sound card installation. Have it ready by your side when you start the
sound card installation.
§If you have an existing sound card (that is non-Plug-and-Play-based)
installed in your computer, you must first un-install its audio drivers
before you remove the sound card. Refer to your existing sound card
documentation for more details on this.
If your existing sound card is Plug-and-Play-based, then you can
safely proceed to install your new sound card.
§There is a Jumper Block (J1) on your sound card which allows you to
switch between Line-Out and Speaker mode.
If you are using an amplified/active speakers with your sound card,
leave this jumper at its current default setting (Line-Out mode).
However, if you are connecting a normal speaker to your sound card,
switch this jumper to the Speaker mode.
Refer to Appendix C for the location of Jumper Block (J1).
SC16-3D Sound Card Users Manual
8
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
1.4 Installing the Sound Card
You need to remove any existing sound card installed in your computer.
Note that if the sound card is non-Plug-and-Play-based, you need to un-
install its audio drivers before you remove it. Check your existing sound
card documentation for details on this.
Remember to switch off your computer and any connected devices before
starting with the installation of your sound card.
Remove your computers chassis cover and set it aside somewhere out
of your way.
9
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Chapter 1 Setting Up Your Sound Card
ENGLISH
Select an available ISA Bus slot. If necessary, remove its cover plate.
Keep the mounting screw to secure your sound card later.
Mou nti ng Scr ew
Cover Plate
ISA-Bus Slot
SC16-3D Sound Card Users Manual
10
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ENGLISH
Align your sound card with the selected ISA Bus slot and firmly push
it into the slot. If the sound card will not slide in, do not force it. Make
sure the sound card is lined up properly and try again.
¸
¸
Sound Card
Altri manuali Aztech Scheda audio
